Overview
The Go Rhino Exterior Front Fender Jack Mount in black, part number 701003T, is a driver side front mount for high clearance off-road and farm jacks on the Jeep Wrangler JK and JKU. It holds the jack in a vertical position on the side of the vehicle to save space. The mount attaches to the hood cowl and lower rocker panel using factory mount points, and its design is rattle-free while driving.
The mount can be used with side bars and steps. Its hardware is Geomet coated for corrosion resistance. Installation is no-drill, and the mount carries a 5-year warranty.
Key features
- Driver side front exterior placement
- Holds high clearance off-road and farm jacks vertically
- Mounts to hood cowl and lower rocker panel
- Attaches to pre-existing factory mount points
- Rattle-free design to keep the jack from damaging the vehicle while in motion
- Geomet coated hardware
- Compatible with side bars and steps
Using a side-mounted jack
A jack mounted on the driver side front fender holds the jack vertically, which keeps the rest of the vehicle side clear. Weight sits on the front corner, so the mount and the factory mount points carry the load every time you drive over rough ground. Look at the mount points for rust or paint damage during regular checks, since a small problem there can grow.
Before each trip, make sure the jack is fully seated and locked, and that the base and handle clear the tire and any side steps when the wheel turns. A side-mounted jack adds width on one side, which can change how the vehicle sits on steep or uneven ground, so keep the load secured and confirm doors and steps still open freely.
- Check mount points for rust or cracked paint
- Keep the jack secured before driving
- Recheck hardware after rough trail use
Specifications
| Brand | Go Rhino |
|---|---|
| Part number | 701003T |
| Position | Driver side front |
| Finish | Black textured powder coat |
| Mounts to | Hood cowl and lower rocker panel |
| Hardware | Geomet coated |
| Installation | No drilling |
| Warranty | 5 year |
Vehicle fitment
The mount fits the 2007–2018 Jeep Wrangler JK in 2-door and 4-door models, and it is designed for the Wrangler JK and JKU. Confirm fit for your vehicle’s year, model and trim before ordering.
Other Wrangler generations, including the JL and TJ, are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The mount attaches to factory mount points on the hood cowl and lower rocker panel. Its hardware is Geomet coated, and installation needs no drilling.
What’s included
Driver side front mount with Geomet coated hardware. Check the package contents against your installation before starting, and plan for the high clearance jack separately.
Not included: the high clearance jack.











