Overview
The Edge 98607 is a pressure sensor for the Edge Accessory System (EAS), a universal fit accessory that works with the Edge CS and CTS gauge platforms.
The Edge Accessory System accepts additional accessories through daisy-chain connections, so this sensor can share a gauge platform with other sensors. Confirm the pressure range, units and measurement limits before relying on a reading.
Key features
- Pressure sensor for the Edge Accessory System
- Daisy-chains with other EAS accessories
- Works with the CS and CTS platforms
- Universal fit
Pressure sensing on a gauge platform
Pressure readings are only as good as the connection that feeds them. Fittings must seal, lines must be free of kinks and air, and the sensor port should be installed in a spot that sees steady pressure rather than pulsation. A restrictor or snubber can smooth rapid changes, but it also slows response, so the choice depends on the pressure source and the line layout.
Before trusting a reading, compare it against a mechanical gauge or a known reference when the engine is at a steady state. A reading that differs widely may point to a leak, trapped air, a damaged sensor or a wiring fault. Recheck the fittings and wiring after the first few drives, since heat and vibration can loosen connections over time.
- Seal each fitting and check for leaks
- Bleed air from the line where the setup allows
- Compare readings against a reference gauge
Specifications
| Brand | Edge |
|---|---|
| Part number | 98607 |
| UPC | 7000579219 |
| Type | Pressure sensor |
| Fitment | Universal fit |
| Compatible platforms | CS and CTS |
Vehicle fitment
This accessory is universal fit and is not vehicle-specific. Its use depends on your gauge platform being a CS or CTS unit, so confirm that before buying.
What’s included
Confirm the package contents match your installation plan before starting.









