Overview
The Edge gauge pillar adapter for CS and CTS, part number 98004, mounts an Edge CS or CTS monitor in a 2-1/16 inch gauge pillar pod. It suits owners who want to replace existing gauges or prefer a clean, finished look.
The adapter has a swivel system so the monitor can be angled to your preferred viewing angle. It is a universal fit that works with most 2-1/16 inch gauge mounts, so it is an accessory rather than a vehicle-specific part.
Key features
- Universal 2-1/16 inch gauge pillar adapter for CS and CTS
- Swivel adjustment for viewing angle
- Screw-tight locking connectors
- Works with most 2-1/16 inch gauge mounts
- Lets CS or CTS monitors replace existing gauges in a pod
Mounting and viewing angle
A pillar pod mount puts the monitor in your line of sight, so placement matters as much as fit. Before choosing a spot, consider how far the monitor sits from the steering wheel, how the cable will route behind the pod, and whether glare from the windshield will wash out the display. A swivel adapter gives some room to adjust, but it cannot fix a pod that sits too low or too far from the driver.
Once the angle is set, tighten the locking connectors and recheck them after a few drives, since vibration can loosen any mount. Keep wiring clear of pedals and moving controls, and leave a little slack so the monitor can be adjusted without strain on the cable.
- Set the viewing angle before final tightening
- Route cables away from pedals and linkages
- Recheck connectors after the first few drives
- Test glare at the time of day you drive most
Specifications
| Brand | Edge |
|---|---|
| Part number | 98004 |
| UPC | 810115011378 |
| Compatible monitors | Edge CS and CTS |
| Mounting size | 2-1/16 inch gauge pillar pod |
| Adjustment | Swivel |
| Connectors | Screw-tight locking |
Vehicle fitment
Fitment is not confirmed by vehicle. The adapter is a universal fit for CS and CTS gauge pods and is not tied to a specific make, model or year. Measure your existing gauge pod to confirm it is a 2-1/16 inch opening before installing.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Confirm the pod size first, since the adapter is built for 2-1/16 inch mounts. Check drilling, wiring and hardware needs against your installation before starting.
What’s included
Check the package contents against your installation before starting. Not included: the Edge CS or CTS monitor itself, since the adapter is an accessory for those products.









