Overview
The Edge 18402 is a replacement pillar mount for CS2 and CTS2 gauges. It is a direct-fit replacement pillar mount with the part number EDG18402, and it fits 2011 to 2016 Ford F-250 and F-350 Super Duty models.
Edge presents this mount as a way for CS2 and CTS2 owners to add a factory-finish look. It is made from .125″ ABS plastic with vacuum-formed edges and comes with an adaptor mount. The mount is adjustable, so the gauge can be positioned for easier viewing.
Key features
- Adaptor mount for CS2 and CTS2 gauges included
- Made from .125″ ABS plastic
- Vacuum-formed edges
- Adjustable for easier viewing
- The mount is designed for a close fit and finish.
Replacing an old pillar mount
Replacing a pillar mount is usually a small job, but the old mount should be removed carefully so the trim or pillar surface is not damaged. Note how the old mount attaches and whether any clips or adhesive were used. Clean the surface before fitting the new mount so it sits flat.
Gauge clarity depends on the mount angle, so set the pod where the gauge face is easy to read from the driver seat. Check that the new adaptor fits the gauge model you own, and confirm the mount does not block the windshield view or any controls. Once fitted, check the gauge with the engine running and watch for vibration that could loosen the mount. Keep the old mounting hardware until the new mount is confirmed.
- Note how the old mount attached
- Clean the mounting surface
- Test the gauge before final tightening
Specifications
| Brand | Edge |
|---|---|
| Part number | EDG18402 |
| Mount type | Replacement pillar |
| Fitment | Direct fit |
| Material | ABS plastic |
| Thickness | .125″ |
| Included | Adaptor mount for CS2 and CTS2 |
Vehicle fitment
It fits the 2011 to 2016 Ford F-250 Super Duty and F-350 Super Duty in the King Ranch, Lariat, Platinum, XL and XLT trims.
Super Duty model years outside 2011–2016 are not in the list, and no other Ford models are named. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Test-fit the adaptor mount against your gauge before final mounting. Have the fasteners and tools for your install ready before you begin.
What’s included
One replacement pillar mount with a CS2 and CTS2 adaptor mount.
Not included: A CS2 or CTS2 gauge is needed to use the mount.









