Overview
The Daystar KU70115ST is a bump stop can mount, designed to be welded to the frame or vehicle chassis for front or rear suspension applications. It is built to hold Daystar Stinger bump stops in place.
It is designed to fit most 2-inch diameter Bilstein, Fox or Sway-A-Way hydraulic or air bumps. It is universal fit, so no specific vehicle is attached.
Key features
- Precision CNC laser cut construction
- Double pinch design for maximum strength and even clamping
- Designed for front or rear suspension applications
- Fits Daystar Stinger bump stops and most 2-inch diameter bumps.
Weld location and alignment
A bump stop can mount sets where the stop meets the bump, so its position controls when the stop starts to work. Before welding, set the bump stop model and the mount together, then check the stop’s contact point at full compression. A mount that is a little out of line can push the stop to one side and wear the bump unevenly.
Welding a mount to a frame or chassis changes that structure, so choose a location that is clean, flat and solid. Remove paint and rust from the weld area, and avoid spots near fuel lines, brake lines or wiring. If the frame section is thin or already corroded, a stronger mounting spot is a better choice than a marginal one.
After welding, check the mount for cracks around the weld and recheck the stop’s alignment on the first few drives. Re-check the bump stop mounting bolts or fasteners on a regular service schedule, since vibration on trails can loosen them over time.
- Clean the weld area to bare metal
- Keep clear of fuel, brake and wiring lines
- Recheck alignment after the first drives
Specifications
| Brand | Daystar |
|---|---|
| Part number | KU70115ST |
| UPC | 618089004293 |
| Type | Bump stop mount |
| Bump diameter | 2-inch diameter bumps. |
| Fitment | Universal fit |
Vehicle fitment
It is a universal-fit mount, so no year, make, model or trim is attached. Fit depends on your bump stop model and where the mount can be welded on your frame or chassis.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The mount is designed to be welded to the frame or vehicle chassis, so installation requires welding and a suitable weld location. Plan for that before ordering.
What’s included
Not included: the Daystar Stinger bump stop, which this mount is designed to fit.














