Overview
The Daystar KU70056AG is a D-ring isolator for standard 3/4 inch d-rings and shackles. It is a polyurethane isolator that snaps onto the shackle so the metal does not tap against a bumper or other recovery point while the vehicle is moving. Because the isolator covers the shackle body, the steel is kept off the surface it would otherwise strike on rough trails. It is a universal fit, so it is not built for a specific vehicle year, model or trim.
Off-road recovery gear is noisy, and steel shackles can scratch paint on a bumper. The D-Ring Isolator sits between the shackle and the anchor point to protect both surfaces. It comes as a pair. Daystar also lists winch isolators, jack isolators, bump stops and dash panels in its wider off-road line.
Key features
- Polyurethane construction that absorbs contact between the shackle and the bumper
- Snaps onto standard 3/4 inch d-rings and shackles
- Stops shackle tapping while the vehicle is in motion
- Helps protect the bumper finish from scratches caused by d-ring contact
- Protects anchor points and bumpers from surface damage
- Comes as a pair
- Limited lifetime warranty
Shackle contact and wear
Steel shackles rarely cause trouble on their own. The damage usually starts where the bow or pin rubs against a bumper, a tow point or a mounting tab. Each bump on a rough trail moves the shackle a little, and that repeated contact can chip paint, dull chrome and wear the pin hole over time. An isolator reduces that contact, but it only works when it stays in place and covers the point that moves the most.
Polyurethane handles this job well because it is firm enough to hold its shape and soft enough to absorb small impacts. Still, it ages. Heat, sun and grit slowly stiffen the material, and a worn sleeve can loosen. Check the isolator every time you clean your recovery gear, and look at the bumper underneath it for fresh scuffs that would show the sleeve has moved.
- Look for cuts, cracks or flattened areas in the polyurethane
- Check that the isolator grips the shackle without slipping
- Inspect the pin and the shackle bow for bends or heavy wear
- Clean grit out from under the sleeve before refitting it
Specifications
| Brand | Daystar |
|---|---|
| Part number | KU70056AG |
| UPC | 618089004842 |
| Material | Polyurethane |
| Fits | Standard 3/4 inch d-rings or shackles |
| Quantity | Pair |
| Warranty | Limited lifetime |
| Fitment | Universal fit |
Vehicle fitment
It is a universal fit, so the match depends on the diameter of your d-ring or shackle rather than on your vehicle.
Check that the shackle is 3/4 inch before using it, since the isolator is sized for that diameter.
Installation notes
The isolator snaps onto the shackle and can be installed or removed in moments. Before a recovery, check that the polyurethane covers the point where the shackle meets the bumper or anchor.
What’s included
A pair of D-Ring Isolators.
Not included: the shackle or d-ring the isolator is fitted to.









