Overview
The Daystar PA913 is a 3 inch body lift kit for 4WD CJ-5 and CJ-7 Scrambler models. It adds 3 inches of body lift and allows use of up to 33-inch diameter tires with factory rims. The kit uses high pressure fiberglass reinforced nylon lift blocks and a clutch pivot bracket. Installation takes 3 to 4 hours.
Key features
- 3 inch body lift for 33-inch diameter tire clearance
- Fiberglass reinforced nylon body blocks
- Laser cut and zinc plated brackets
- High strength hardware included
- Clutch pivot bracket included
Clearance after a body lift
On older CJ frames, a body lift separates the body from the frame by a set height, which gives tires room to move up under the fenders. Because the body sits higher, the wiring, fuel lines and the hood alignment all change, so the job includes more than bolting in the blocks.
Lift blocks made of reinforced nylon are a common choice for this type of lift because they resist compression and do not rust. Check the blocks and hardware for cracks or loosening after the first trail runs, and retighten bolts once the body has settled. Steering and throttle linkage should also be checked for length and free travel after the body moves.
- Check the hood gap and latch after installation
- Look at fuel line routing near the body mounts
- Recheck the body bolts after the first several drives
- Confirm the windshield washer lines still reach
Specifications
| Brand | Daystar |
|---|---|
| Part number | PA913 |
| UPC | 618089006198 |
| Lift height | 3 inches |
| Drivetrain | 4WD models |
| Tire capacity | Up to 33-inch diameter tires |
| Lift blocks | High pressure fiberglass reinforced nylon |
| Brackets | Laser cut and zinc plated |
| Install time | 3 to 4 hours |
| Origin | Made in USA |
Vehicle fitment
The kit fits the Jeep CJ5 (1959-1983) and CJ7 (1976-1986) 4WD models, including the CJ-7 Scrambler. Verify your year, model and trim before buying.
The kit is for CJ-era models, so do not assume it fits Wrangler (YJ) or later vehicles.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation takes 3 to 4 hours. Check clearance to the wiring and fuel lines after lifting, since the body moves relative to the frame.
What’s included
The kit includes fiberglass reinforced nylon lift blocks, a clutch pivot bracket, high strength hardware and laser cut zinc plated brackets.
Not included: Bumper brackets are not part of this kit.









