Overview
The Crown Automotive 5066064AA is a Dana 30 snap ring for the front axle of the 2002-2007 Jeep Liberty KJ. Crown also catalogs it as CRO5066064AA, and describes its job as securing the bearing.
The ring sits at the front inner position on the Dana 30 axle.
Crown Automotive says nothing further about the 5066064AA, so no diameter, thickness or finish is given for the ring. Compare the new ring with the old one in the Dana 30 front axle before it goes in, and confirm the Liberty is a KJ built between 2002 and 2007.
A snap ring holds a bearing in place, and this one is the retainer for the Dana 30 front axle of the Liberty KJ. It sits at the front inner position. Compare it with the ring being replaced before installing.
It is a direct fit for the 2002 to 2007 Jeep Liberty KJ, including the Sport, Limited and Renegade trims.
Crown Automotive is a long-standing maker of Jeep replacement parts, with over 8,000 part numbers, including many factory-discontinued items.
Key features
- Snap ring for the Dana 30 front axle
- Secures the bearing
- Front inner position
- Direct fit for the 2002-2007 Liberty KJ
Replacing a snap ring safely
A snap ring holds the bearing in its position on the axle, so a ring that moves or slips can allow the bearing to walk out of place. Use snap ring pliers that fit the ring, and seat the ring fully in its groove before reassembling the axle. Wear eye protection, since snap rings can spring out with force during removal.
Inspect the groove for burrs, corrosion or wear, and clean away debris before the new ring goes in. Check that the bearing and the cover or hub are in the right order, and rotate the assembly by hand after installation to confirm there is no binding. Replacing the ring with a new one is a safer choice than reusing an old one, because a bent ring may not hold.
- Use snap ring pliers that fit the ring
- Check the groove for burrs or corrosion
- Rotate the assembly by hand after installation
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 5066064AA |
| UPC | 848399033991 |
| Product type | Snap ring |
| Also cataloged as | CRO5066064AA |
| Axle | Dana 30 front |
| Function | Secures the bearing |
| Position | Front inner |
| Fit type | Direct fit |
Vehicle fitment
It fits the 2002–2007 Jeep Liberty (KJ) in the 65th Anniversary Edition, Limited, Renegade, Rocky Mountain Edition and Sport trims.
- 2002–2007 Jeep Liberty (KJ) (65th Anniversary Edition, Limited, Renegade, Rocky Mountain Edition, Sport)
Only the Liberty KJ is listed. The later Liberty and other Jeeps with a Dana 30 are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The snap ring retains a bearing on the Dana 30 front axle, so use snap ring pliers and check it seats fully in its groove.
What’s included
One snap ring.








