Overview
The Crown Automotive J0923896 is a transfer case output shaft seal for Jeep transfer cases. It seals the opening where the output shaft leaves the case, helping keep lubricant inside. The product is marked direct fit, with no vehicle years or chassis codes.
Key features
- Replacement transfer case output shaft seal
- Part number J0923896 and UPC 848399054736
- Marked as a direct fit
- A replacement Jeep part for transfer cases from Crown Automotive
Seal replacement checklist
A transfer case output shaft seal is a small part with a big job, keeping lubricant in and water out at the point where the shaft leaves the case. Many seals fail from age, shaft wear or a damaged yoke rather than from the seal itself. Before ordering, check the transfer case model, the shaft size and the seal’s outer dimensions against the old seal.
Removing the old seal usually requires draining fluid and pulling the yoke or flange. Clean the bore, check for grooves on the shaft and install the new seal square with a proper driver. Lubricate the lip lightly with transmission fluid before installing. After refilling, check for leaks around the seal over a few short drives.
- Compare the old seal before buying
- Inspect the yoke and shaft for wear
- Check the fluid level after refilling
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J0923896 |
| UPC | 848399054736 |
| Part type | Transfer case output shaft seal |
| Fitment | Direct fit (no years or models stated) |
Vehicle fitment
It is a direct fit. Confirm fit for your vehicle’s year, model and transfer case before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
The package contains one seal, part number J0923896. Check the package contents against your installation before starting.
