Overview
The Crown Automotive Temperature Gauge, part number 640762, is a 2 in diameter, 6-volt temperature gauge that reads from 100 to 220 degrees F. It is offered as an O.E. replacement gauge for 1943-1947 Jeep Willys vehicles.
It is a direct fit for the Willys models covered in the vehicle fitment section. The UPC is 849603015321.
Key features
- 2 in diameter
- Reads 100-220 degrees F
- 6-volt rating
- O.E. replacement gauge mounting size, direct fit
Sender matching and installation
A temperature gauge only reads as accurately as the sender feeding it, so confirm the sender type and its resistance range match the gauge before wiring. Older Willys electrical systems vary, and a gauge that reads high or low often points to a sender or wiring fault rather than the gauge itself. Test the circuit with the engine cold and then warm to see whether the needle tracks the change.
Route the gauge wire away from exhaust heat and moving linkage, and use clean, tight connections at the sender and the gauge back. Check the gauge face for clear reading at dash height before tightening the mounting bezel. Keep a meter handy when connecting the 6-volt circuit so you can confirm power and ground before you start the engine.
- Match the sender to the gauge
- Keep wiring clear of exhaust heat
- Verify power and ground before starting
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 640762 |
| UPC | 849603015321 |
| Diameter | 2 in |
| Temperature range | 100-220 degrees F |
| Voltage | 6 V |
| Gauge mounting size | O.E. replacement |
| Fitment type | Direct fit |
Vehicle fitment
It fits these Jeep Willys vehicles: 1947 Jeep Willys 1-Ton, 1947 Jeep Willys 463, 1943-1947 Jeep Willys CJ-2, 1946-1947 Jeep Willys Panel and 1947 Jeep Willys Truck.
Models outside the Willys entries above are not in this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The gauge is the item included. Confirm the sender, wiring and any other hardware you need before ordering.









