Overview
The Crown Automotive pilot bushing (part number J3752487) is a replacement pilot bushing for the transmission input shaft. It is noted for 2.5L 4 cylinder and 225 V6 engines.
The bushing fits Jeep CJ5, CJ6, CJ7, Commando and Scrambler models in 1966–1971 and 1981–1983, depending on model.
Key features
- Replacement pilot bushing for clutch and input shaft alignment
- Noted for 2.5L 4 cylinder and 225 V6 engines
- Fitment listed across five Jeep models
- Part number J3752487 with UPC 848399061895
Pilot bushing care
The pilot bushing supports the front of the transmission input shaft, keeping it centered in the crankshaft bore as the clutch engages. When it wears, the input shaft can wobble, which shows up as vibration, a rough engagement or a whine at speed in neutral. A bushing that spins or shows scoring inside the bore should be replaced rather than reused.
Because the bushing sits inside the crankshaft, it is usually replaced together with the clutch disc, pressure plate and release bearing, since all of them come off in the same job. Clean the bore thoroughly, check for scoring, and lubricate the bushing lightly before fitting the input shaft. Use a fitting tool or a light, even press so the bushing does not tilt.
- Input shaft wobble or vibration
- Scoring inside the crankshaft bore
- Rough clutch engagement
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J3752487 |
| UPC | 848399061895 |
| Part type | Pilot bushing |
| Engine applications | 2.5L 4 cylinder and 225 V6 engines |
| Outside diameter (OD) | 1.093 inch |
| Inside diameter (ID) | .586 inch |
| Width | .750 |
Vehicle fitment
It fits 1966–1971 and 1981–1983 Jeep CJ5 (Base, Laredo, Limited, Renegade), 1966–1971 Jeep CJ6 (Base), 1981–1983 Jeep CJ7 (Base, Laredo, Limited, Renegade), 1966–1971 Jeep Commando (Base) and 1981–1983 Jeep Scrambler (Base, SL, SR).
CJ7 years outside 1981–1983 and Wrangler models are not on this fitment. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A pilot bushing sits in the crankshaft bore, so replacing it normally means removing the clutch and transmission first.
What’s included
This item is one pilot bushing.
Not included: clutch discs, pressure plates and transmission parts are not part of this item.









