Overview
The Crown Automotive 52128864AA is a black rubber rear lower control arm bushing for the body side of the 2004-2007 Jeep Liberty (KJ). It is a press-in part that fits the 65th Anniversary Edition, Limited, Renegade, Rocky Mountain Edition and Sport trims.
The body side end of the lower arm is the frame-mounted pivot, so this part replaces that bushing rather than the axle-side one.
Key features
- Rear lower position, body side
- Black rubber construction
- Press-in design
- Direct-fit listing for the 2004–2007 Jeep Liberty (KJ)
- Crown Automotive part number CRO52128864AA
Frame-side pivot wear
The body side end of a lower control arm carries the arm’s pivot against the frame. Under load and on rough roads that rubber can crack, soften and let the arm shift, which affects steering feel and tire wear.
Vehicles used on rough trails or for towing tend to show wear sooner than daily-driven vehicles. Inspect the bushing, the frame bracket and the nearby fasteners during service, and look for cracks or loose hardware before fitting a new bushing.
Press-in bushings need a clean bore and an even press, so plan the job with the arm supported and the right tool. After installation, confirm steering and tracking on a short test drive and have the alignment checked if tire wear has been uneven.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52128864AA |
| UPC | 848399040876 |
| Position | Rear lower, body side |
| Color | Black |
| Material | Rubber |
| Installation | Press in |
| Fit type | Direct fit |
Vehicle fitment
It fits the 2004-2007 Jeep Liberty (KJ) in the 65th Anniversary Edition, Limited, Renegade, Rocky Mountain Edition and Sport trims. Years and models outside this fitment are not covered.
Years outside 2004–2007 and other Jeep models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Seating this press-in bushing takes a press rather than wrenches alone, and the press tool is not part of this item.
What’s included
The package is one rear lower control arm bushing for the body side.
Not included: the control arm and the press tool used to seat the bushing.









