Overview
The Crown Automotive 52089065AA is a black rubber rear lower control arm bushing for the axle side of the 2002-2003 Jeep Liberty (KJ). It is a press-in bushing that fits the Limited, Renegade and Sport trims.
This part is the rear lower control arm bushing on the axle side, so it replaces the worn pivot at that joint rather than the upper one.
Key features
- Rear lower position on the axle side
- Black rubber construction
- Press-in design
- Direct-fit listing for the 2002–2003 Jeep Liberty (KJ)
- Crown Automotive part number CRO52089065AA
Press-in work and tools
A press-in bushing is seated into the control arm bore rather than bolted in place, so the arm usually has to come off the vehicle first. Support the arm firmly, clean the bore thoroughly and check it for burrs or distortion before pressing the new bushing in.
Press the bushing square and evenly, and stop when it reaches the seat. Uneven pressing can tear the rubber or cock the sleeve, which leads to noise and early wear. Use a press tool that matches the bushing so the load goes through the outer housing.
Before choosing this part, measure the old bushing’s outer diameter and bore and compare them with your arm. Replace any fasteners that were disturbed, and recheck alignment after the vehicle has been driven a short distance.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52089065AA |
| UPC | 848399039702 |
| Position | Rear lower, axle side |
| Color | Black |
| Material | Rubber |
| Installation | Press in |
| Fit type | Direct fit |
Vehicle fitment
It fits the 2002-2003 Jeep Liberty (KJ) in the Limited, Renegade and Sport trims. Years and models outside this fitment are not covered.
Years outside 2002–2003 and other Jeep models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because it is a press-in style, the bushing is pressed into the control arm rather than bolted in place. A press tool is needed for that step and is not part of this item.
What’s included
The title describes one rear lower control arm bushing.
Not included: the control arm and the press tool needed to seat the bushing.









