Overview
The Crown Automotive indicator lamp switch, part number J3211322, is designed for Dana 300 and Quadra-Trac transfer cases. Its top has one brass stud that accepts a push-on wire connection.
The manufacturer fitment list covers 1973–1986 Jeep Cherokee SJ, CJ5, CJ7, J-series trucks, Scrambler and Wagoneer SJ models, with the specific years and trims shown below.
Key features
- Designed for Dana 300 and Quadra-Trac transfer cases
- One brass stud on top for a push-on wire connection
- Fits 1973–1986 Jeep SJ, CJ, J-series, Scrambler and Wagoneer models
- Replacement indicator lamp switch from Crown Automotive
Testing the indicator circuit
An indicator lamp switch typically signals the dash light when the shifter moves into a given position. When the light flickers, stays on or never comes on, the switch, its wire or the bulb circuit may be the cause. Check the wire connection at the brass stud first, since a loose push-on connector is a common source of intermittent faults.
Testing with a multimeter across the switch terminals shows whether it opens and closes as the shifter moves. Replace the switch if it shows no continuity when it should, and inspect the ground path as well. Keeping the connection sealed against moisture can prevent corrosion on the stud.
- Check the push-on connector for corrosion or looseness
- Test continuity with the transfer case in each position
- Inspect the wiring harness near the transfer case
- Replace the switch if the circuit fails the test
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J3211322 |
| UPC | 848399059427 |
| Component | Indicator lamp switch |
| Transfer case compatibility | Dana 300 and Quadra-Trac |
| Terminal | One brass stud on top, push-on wire connection |
Vehicle fitment
Manufacturer fitment lists 1974–1979 Jeep Cherokee (SJ); 1980–1983 Jeep CJ5; 1976–1986 Jeep CJ7; 1973 Jeep J-2500, J-2600, J-4500, J-4600, J-4700 and J-4800 (Base); 1974–1979 Jeep J10 and J20 (Base); 1981–1985 Jeep Scrambler; and 1973–1979 Jeep Wagoneer (SJ).
It does not cover Wrangler, Grand Cherokee or later Jeep models, or years outside the ranges above. Check your year and trim against those ranges before buying.
Installation notes
The wire attaches by pushing a connector onto the brass stud on top of the switch. Confirm the switch suits your transfer case before fitting it.
What’s included
The switch is the only item supplied. Wiring and connectors are not included, so plan any harness work separately.












