Overview
The Crown Automotive 83500300 is a standard-size connecting rod bearing for Jeep engines. It fits CJ, Cherokee SJ, J-series, Wagoneer and early Wrangler YJ models from 1971 to 1991. Confirm the bearing size against your engine and your model year before ordering.
It is a direct fit replacement bearing. The number needed depends on your engine, so count bearings against the engine before ordering.
Key features
- Standard size connecting rod bearing
- Quantity notes of 6 needed and 8 needed
- Marked Direct Fit under Crown Automotive part number 83500300
- It fits 1971 to 1991 Jeep models, including CJ, SJ and YJ
Checking bearing clearance
Connecting rod bearings carry load between the crankshaft and rod, and their fit decides how well the oil film holds up under load. Clearance is checked with a measuring tool during assembly, often with plastigauge or a micrometer. Keep the crankpin and bearing surfaces clean and free of nicks before the new shells go in, since debris can score a fresh bearing within a short run.
Old bearings often show wear as a dull or polished surface, uneven marks on one side, or copper showing through the surface. Any of these means the crankshaft or the rod may need attention too. Oil passages should be clear, and the oil pump should be checked when a full bottom-end rebuild is underway.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 83500300 |
| UPC | 848399023312 |
| Part type | Connecting rod bearing |
| Size | Standard |
| Quantity notes | 6 needed and 8 needed |
| Fitment marking | Direct Fit |
| Category | 72-86 6 Cylinder Engine Parts |
Vehicle fitment
It fits CJ5 (1971–1983), CJ6 (1971–1975), CJ7 (1976–1986), Cherokee SJ (1974–1983), Commando (1972–1973), DJ5 (1973–1983), Scrambler (1981–1985), Wagoneer SJ (1972–1983), Grand Wagoneer SJ (1984–1991), J-series trucks (1971–1988) and Wrangler YJ (1987–1990).
It does not fit Cherokee XJ, Wrangler TJ or any Wrangler model after 1990. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Rod bearings are replaced during an engine teardown, which means removing the oil pan and rod caps. Bearing clearances should be measured during assembly, so this work suits an engine builder or a mechanic with rebuild experience.
What’s included
The package is the connecting rod bearing itself. Count the bearings needed for your engine before starting.









