Overview
The Crown Automotive Drive Shaft Slip Yoke Boot, part number 4798123, is a replacement boot for the slip yoke of a Jeep drive shaft. It is for vehicles with an NP231 or NP242 transfer case and is a direct fit.
Crown Automotive has produced replacement parts for Jeep vehicles for over 50 years, and this boot is one of them.
Key features
- Slip yoke boot for a Jeep drive shaft
- Fits NP231 or NP242 transfer case vehicles
- Direct fit for these transfer cases
- Part number 4798123 and UPC 70000639618
Slip yoke boot service
The slip yoke boot keeps grease in and dirt out of the spline area where the drive shaft slides as the suspension moves. When it tears, grease can leak out and grit can work into the spline, which leads to noise, vibration and faster wear on the yoke. Look for cracks, splits or a boot that has pulled away from its seat during routine inspections.
Replacing the boot is a good time to inspect the spline for wear, check the slip yoke for scoring, and look at the transfer case seal for leaks. Clean the yoke and boot seat before fitting the new boot, and use fresh grease for the spline as the installation calls for. Make sure the clamp seats evenly so the boot does not rotate or tear early.
- Inspect the spline for wear while the boot is off
- Clean grit from the yoke before fitting
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 4798123 |
| UPC | 70000639618 |
| Part type | Drive shaft slip yoke boot |
| Transfer case | NP231 or NP242 |
| Fitment | Direct Fit |
Vehicle fitment
It is a direct fit for NP231 or NP242 transfer cases. Confirm fit for your vehicle’s year, model and trim before ordering, and check your transfer case before buying.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents against your installation before starting, including whether a clamp is needed.









