Overview
The Crown Automotive J0801367 is a Dana 300 output shaft yoke nut for front or rear yokes. It secures the yoke on the Dana 300 output shaft, so the Dana 300 unit is the application to confirm first.
Part number J0801367 and UPC 848399053456 identify it, and the fitment type is Direct Fit.
Key features
- Output shaft yoke nut for the Dana 300
- Made for front or rear yokes
- Direct Fit fitment type
- Identified by part number J0801367
Yoke nut installation tips
An output shaft yoke nut holds the yoke against the shaft, so its clamp force is part of the driveline’s security at highway speeds. Loose yoke nuts often cause a clunk on shifts, vibration, or movement at the yoke. Inspect the threads and the yoke bore whenever the nut is removed, since damaged threads can loosen a new nut as well.
Yoke position matters for the setup, so confirm whether your Dana 300 uses a front or rear yoke before choosing the nut. When the yoke is pulled off, clean the mating faces, check the yoke seal for leaks, and inspect the shaft for wear. Tighten the nut to the value in your service procedure and re-check it after the first few drives.
- Clean mating faces before reinstalling the yoke
- Inspect the yoke seal while the yoke is off
- Re-check the nut after the first few drives
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J0801367 |
| UPC | 848399053456 |
| Component | Output shaft yoke nut |
| Application | Dana 300 output shaft |
| Yoke position | Front or rear |
| Fitment type | Direct Fit |
Vehicle fitment
No vehicles are named for this yoke nut. Only the Dana 300 is stated, so confirm the unit and vehicle before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
The Dana 300 output shaft yoke nut, part number J0801367.
Not included: the yoke and output shaft, which are separate parts.









