Overview
The Crown Automotive brake backing plate mounting bolt, part number J0994313, is a single mounting bolt for a brake backing plate. It is named for a Dana 44 rear axle and is sold individually.
Compare thread, length and grade with the fastener you remove before installing the new bolt, so the replacement matches the original.
Matching the old bolt
A backing plate bolt holds the brake backing plate to the axle housing flange, so it carries the plate’s load and resists the twisting that braking creates. Because it sits close to the brake drum and hub, it sees dirt, water and heat cycles that can slowly loosen or corrode the threads. A bolt that has stretched, rounded or rusted at the head should be replaced rather than reused.
When selecting a replacement, start by matching the thread pattern, length and head style of the original bolt. A bolt that is too short or of a lower grade can leave the plate loose under braking. Use the original fastener as the reference, and take it to a parts counter if the threads are unclear. Clean the bolt hole and mating surface before installation, then tighten it to the torque your repair requires.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J0994313 |
| UPC | 848399057300 |
| Part type | Brake backing plate mounting bolt |
| Application | Dana 44 rear axle |
| Sold | Individually |
Vehicle fitment
No vehicle year, model or chassis code is given for this bolt. The Dana 44 rear axle names an axle, not a vehicle, and the Direct Fit label does not identify a Jeep model.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
One bolt is sold individually. No hardware, washers or other items are mentioned.









