Overview
The Crown Automotive J0994904 is an inner rear axle shaft seal for the driver or passenger side. It fits the 1974–1983 Jeep J10 and J20 pickups.
An inner axle seal stops gear oil from leaking where the axle shaft leaves the differential. This one is for the rear, and it fits either the driver or the passenger side, so the same part number serves both ends of the axle.
Match it to your vehicle and axle position before installing. It is a direct-fit replacement for the J10 and J20 in base trim.
Gear oil that escapes past a rear inner seal can reach the brake linings and the axle tube, so a leaking seal is worth addressing early rather than waiting. J10 and J20 owners can also use the same part number for both sides, which reduces the number of seals to track when the axle is serviced.
Crown Automotive makes Jeep replacement parts, and this seal covers the J10 and J20 pickups built from 1974 to 1983.
It is a rear inner seal for either side, so confirm the side against the old part before installing.
Key features
- Inner axle shaft seal
- Rear position
- Fits the driver or passenger side
- It fits 1974 to 1983 Jeep J10 pickups.
- It fits 1974 to 1983 Jeep J20 pickups.
- Direct-fit replacement part
Why rear seals leak
An inner axle seal sits between the axle shaft and the differential, and it keeps gear oil in the axle housing. When it wears or hardens, oil can creep along the shaft and reach the brake linings, which reduces braking grip. Rear seals take the most heat and road grime, so they can fail sooner than expected on an older truck.
When replacing the seal, drain or check the oil level, remove the axle shaft carefully, and inspect the shaft surface where the lip rides. A grooved or pitted shaft will wear a new seal quickly. Pack the lip lightly with gear oil, drive the seal in square, and refill to the correct level.
Because the same axle often shows worn bearings or a worn pinion seal, look at those while the shaft is out. Wipe the brake backing plate clean of oil before reassembly, since oil left there can soak into new linings.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J0994904 |
| UPC | 848399057362 |
| Part type | Axle shaft seal, inner |
| Position | Rear, driver or passenger side |
| Fitment type | Direct fit |
| Category | Axle parts, inner axle seals |
Vehicle fitment
It fits these 1974–1983 Jeep trucks in base trim:
- 1974–1983 Jeep J10 (Base)
- 1974–1983 Jeep J20 (Base)
It covers the J10 and J20 from 1974 to 1983 only. Other Jeep trucks and later J-series models are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Confirm the seal against your J10 or J20 rear axle before installation.









