Overview
The Crown Automotive 83503108 is a rear adapter seal for AX4, AX5 and AX15 manual transmissions. A rear adapter seal keeps lubricant in at the back of the transmission, where the output shaft passes through the housing.
It fits the 1988–1995 Jeep Wrangler (YJ) and the 1997–2002 Jeep Wrangler (TJ) in the trims named below.
Key features
- Replacement rear adapter seal for AX4, AX5 and AX15 transmissions
- Direct fit for Wrangler YJ and TJ models
- Crown part number 83503108 and UPC 848399025194
Adapter seal and output shaft care
The rear adapter seal sits at the back of the transmission where the output shaft leaves the housing, and it keeps lubricant from escaping along the shaft. Leaks at this point often appear as fluid on the rear of the transmission or dripping onto the transfer case. Shaft wear and worn seal lips are the usual causes, and heat from long highway trips or towing can speed up hardening.
When replacing this seal, clean the adapter housing and inspect the shaft surface for grooves that could cause a new seal to leak. Use the correct fluid for the transmission after the job, and check the level once the vehicle has warmed up. On a Wrangler, the transfer case is close by, so check its seals too when access is open.
- Look for grooves on the output shaft
- Clean the adapter housing before fitting
- Recheck the area for drips after a short drive
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 83503108 |
| UPC | 848399025194 |
| Part type | Rear adapter seal |
| Transmission application | AX4, AX5 and AX15 transmission |
Vehicle fitment
It fits the 1988–1995 Jeep Wrangler (YJ) in Base, Islander, Laredo, Renegade, Rio Grande, S, SE and Sahara trims, and the 1997–2002 Jeep Wrangler (TJ) in SE, Sahara, Sport and X trims.
Cherokee, Comanche and Wrangler JK models are not in this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Only the rear adapter seal is described. No other parts are named.









