Overview
The 31010-11 is a pair of Cut-Out rear fender flares for the 1984 to 1988 Toyota Pickup. The design maximizes off-road wheel travel and tire coverage for oversized tires. The fit covers the Base, Base Turbo, DLX, DLX Turbo, SR5 and SR5 Turbo versions of the pickup.
Cut-Out flares work differently from pocket style flares. They require cutting body sheet metal so the tire can travel further, and Bushwacker says each set is individually designed for its vehicle. The flares are made from Dura-Flex 2000, and the matte black finish can be painted. Cut-Out flares are a different style from pocket style or Extend-A-Fender flares: they remove sheet metal rather than covering it, which Bushwacker says gives the wheel more room to articulate off-road.
Key features
- Cut-Out design that removes sheet metal for more wheel articulation
- 2.25 inches of width and tire coverage
- Rivet installation for a secure fit
- Thick, warp-proof Dura-Flex 2000 construction
- UV protection against chalking
- Matte black finish that is easy to paint
Living with cut-out flares
Cut-out flares leave bare sheet metal at the cut line, which needs protection against corrosion. Clean the edge, treat it with a rust-inhibiting primer and finish with paint before the flare goes on. Repeat the touch-up after any damage, since exposed metal is the first place rust starts.
The cut changes how the rear body is braced, so check for flex or cracks near the cut after rough trail use. Inspect the rivets, tighten any that have loosened, and look at the Dura-Flex edge for cracking around each rivet hole. Keep mud packed out of the gap so it does not trap moisture against the metal.
Clearance can change with tire or suspension upgrades, so measure again whenever the wheel and tire setup changes.
Specifications
| Brand | Bushwacker |
|---|---|
| Part number | 31010-11 |
| UPC | 90689103307 |
| Position | Rear |
| Width and tire coverage | 2.25 inches |
| Quantity | Sold as a pair |
| Fit type | Direct fit |
| Material | Dura-Flex 2000 |
| Finish | OEM matte black, paintable |
| Model years | 1984 to 1988 Toyota Pickup |
Vehicle fitment
Bushwacker lists fitment for the 1984 to 1988 Toyota Pickup. Pickups from 1989 to 1995 are listed under a different part number, so this pair should not be used on those years.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Cut-Out flares require cutting body sheet metal, and the cut is permanent. Bushwacker refers to an installation guide for each specific model, so follow that guide and measure the clearance before any cutting begins.
What’s included
One pair of rear Cut-Out fender flares.
Not included: the front pair (part 31009-11) is sold separately.








