Overview
The Body Armor 4×4 ECO-Series front bumper, part number FD-19336, is a textured black powder coated steel front bumper made from 3 mm plate. The bumper is designed to add strength, protection and a more aggressive look while leaving room for airflow to the intercooler on EcoBoost-powered vehicles.
The center pockets leave room for airflow to the intercooler. The end pockets hold mounting points for two cube LED lights each, and the center takes a 20-inch single or dual row LED bar. At 79 pounds, the bumper is designed to keep weight low enough to avoid bogging down the suspension or hurting gas mileage. Installation is bolt-on with no drilling, cutting or welding required.
Key features
- 3 mm steel plate construction
- Pockets in the center for intercooler airflow on EcoBoost rigs
- Mounting points for two cube LEDs in each end pocket
- Center mount for a 20-inch single or dual row LED bar
- Designed to offer more protection than a factory bumper.
- Dual process textured black powder coat
- Bolt-on installation, no drilling, cutting or welding
- Weighs 79 pounds
Lighting and wiring setup
A bumper with cube and bar mounts is a convenient place for lights, but the wiring needs as much planning as the mounts. Route the harness through the bumper’s pockets and away from the intercooler and hot components, and secure it with loom and clips so it does not rub. Use a fused relay close to the battery and a switch that can be turned off easily.
Light bars are heavy and throw a lot of light, so aim them with care and check local rules on auxiliary lighting before adding them. Confirm the mounts can hold the weight of the lights you choose, and check bolts and tabs after rough trails. Keep the intercooler pockets clear of mud and leaves so airflow is not blocked.
Specifications
| Brand | Body Armor 4×4 |
|---|---|
| Part number | FD-19336 |
| UPC | 859909003656 |
| Product | Front bumper, ECO-Series |
| Material | Steel plate, 3 mm |
| Finish | Textured black powder coat, dual process |
| Bumper weight | 79 lb |
| Width | Full |
| Fit type | Direct fit, bolt-on |
| Light mounts | Included, two cube LEDs per end pocket plus center bar mount |
| Winch mount | Not included |
| D-ring mount | Not included |
Vehicle fitment
The bumper is made for trucks with EcoBoost engines. Confirm fit for your vehicle’s year, model and trim before ordering.
An engine name alone does not identify a vehicle, so do not treat this bumper as a fit for every EcoBoost model. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation is bolt-on and needs no drilling, cutting or welding. If you add LED cubes or a light bar, run them through a fused relay and follow local rules on auxiliary lighting.
What’s included
- Front bumper with intercooler airflow pockets
- Multiple light mounting points
Not included: lights, which are sold separately, and a winch mount.
















