Overview
The Body Armor 4×4 30 Inch LED Light Bar (part 40030) is a 30 inch LED light bar with a driving and combo beam pattern. It is rated at 180 watts and 12600 lumens, and it is universal fit for Jeep, truck and SUV use.
Body Armor 4×4 started as a Jeep owner’s project to build bumpers that fit better and performed well, and it has since grown into an accessory brand covering exterior armor, racks, interior storage, tents, trail accessories and suspension parts. The company describes its warranties as a sign of confidence in the quality of its products.
The bar fits a range of Jeep, truck and SUV applications, and suitability depends on the mounting location and the wiring you run. Plan the fuse and wire size around the 180 watt draw before installing. The bar is a single 30 inch unit, so measure the mounting space before drilling.
Body Armor 4×4’s line runs from exterior armor to suspension, and this light bar is one of its lighting accessories.
Key features
- 30 inch light bar length
- Driving and combo beam pattern
- 180 watts
- 12600 lumens
- Universal fit listed by Body Armor 4×4
Planning the wiring
A 180 watt light bar draws a lot of current, so the wiring is the part of the installation that deserves the most care. Run the feed through a fuse close to the battery, and use a relay so the switch carries only a small load. Pick wire thick enough for the full draw over the run length, and make the ground connection short, clean and tight to bare metal.
Think about switch placement and where the bar will be aimed before you cut any wire. A switch within easy reach of the driver makes it simple to turn the bar off at camp or when oncoming traffic appears. Mount the switch in a dry spot, and use weather sealed connectors at any joint exposed to road spray or mud.
- Fuse the feed close to the battery
- Use a relay for the switch circuit
- Keep ground connections short and clean
Specifications
| Brand | Body Armor 4×4 |
|---|---|
| Part number | 40030 |
| Length | 30 inch |
| Beam pattern | Driving and combo |
| Power | 180 watts |
| Output | 12600 lumens |
Vehicle fitment
The bar is universal fit and is not built for one vehicle, so check the mounting location, bracket and clearance on your vehicle before ordering. Confirm fit for your vehicle’s year, model and trim before ordering. Plan placement around the bar’s 30 inch length and the wiring run to the switch, and size the fuse and wire for the 180 watt rating.
What’s included
The 30 inch LED light bar. Confirm the mounting hardware before ordering.













