Overview
The Baja Designs Squadron-R Sport Fog Pocket Kit, part number 447070, is built for the plastic bumper on the Jeep Wrangler JL Sahara. Two Squadron-R Sport LED lights replace the factory fog pocket lights. It is intended for 2018-2022 Jeep Wrangler JL, 2 and 4 door, Sahara models.
Each light runs four LEDs and is listed at 2,260 lumens and 20W at 1.4A. The hard anodized, powder coated cast aluminum housings measure 3.07″ x 2.77″ x 3.07″, and the LED life expectancy is 49,930 hours.
Key features
- Pair of Squadron-R Sport LED lights
- 2,260 lumens per light from four LEDs
- Wire adapters for the factory connectors
- Brackets that reuse the stock mounting points
- Hard anodized, powder coated cast aluminum housing
- LED life expectancy of 49,930 hours
Sahara bumper and trail use
Sahara trims are often driven on paved roads and light trails, and fog lights help most in rain, fog and dust. A plastic bumper flexes slightly over rough ground, so the mounting points should be checked after a few trips. Keep the brackets snug and inspect the fog pockets for any gaps that could let water in behind the lens.
Good fog light use is mostly about aim and maintenance. Set the lights low enough to show the road edges, and clean the lenses when dust or road salt builds up. If the pocket seals look worn, replace them before water gets to the connectors, since moisture is the usual cause of dim or failing lights.
- Check brackets after rough trips
- Inspect pocket seals for gaps or wear
- Aim low to show road edges
- Clean lenses when dust or salt builds up
Specifications
| Brand | Baja Designs |
|---|---|
| Part number | 447070 |
| UPC | 819314026992 |
| Light model | Squadron-R Sport |
| LEDs per light | 4 |
| Lumens | 2,260 per light |
| Wattage / amps | 20W / 1.4A |
| Dimensions | 3.07″ x 2.77″ x 3.07″ |
| Housing | Hard anodized and powder coated cast aluminum |
| Fitment | 2018-2022 Jeep Wrangler JL, Sahara |
Vehicle fitment
The kit fits 2018-2022 Jeep Wrangler JL, 2 and 4 door, Sahara trims with the plastic bumper. The range follows the JL generation, which begins with the 2018 model year.
Metal Rubicon bumpers use a different kit, part number 447068, and this kit is not for them. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Plug the wire adapters into the OEM connectors and mount the brackets on the factory points. Confirm the vehicle has the plastic Sahara bumper before starting, since the kit is made for that bumper.
What’s included
A pair of Squadron-R Sport LED lights, two sets of Jeep JL mounting brackets, plug and play wiring connectors, and mounting hardware.
