Overview
The Baer Brakes 6801278 is a T4 caliper rebuild kit that services one Baer T4 caliper. It supplies the seals, pad abutment clips and bleeder dust cap used when a T4 caliper is taken apart and rebuilt, and it suits mechanics who work on Baer calipers.
The kit covers the pressure and weather seals that keep fluid and dirt out of the caliper, along with stainless steel pad abutment clips and new banjo crush washers. Fitting the full set during a rebuild keeps the caliper sealed and the pads seated correctly.
If you are unsure which caliper you have, Baer’s tech department can help identify it before you order parts.
Key features
- Services one Baer T4 caliper
- EPDM rubber pressure and weather seals
- Stainless steel brake pad abutment clips
- New banjo crush washers
- Bleeder dust cap included
- O-ring seals with a square rim shape
Signs a caliper needs rebuilding
Caliper seals wear over time, and fluid or dirt that gets past them can cause a sticking piston, uneven pad wear or a soft pedal. Check the caliper body for fluid around the piston and the boot area, and look for scoring in the bore if the piston is hard to push back. A rebuild makes the most sense when the bore is clean and the piston moves freely.
Pad abutment clips hold the pads in place and let them slide. Worn or corroded clips can cause rattling and uneven pad movement, so replacing them along with the seals is common practice. Banjo crush washers seal the fluid fittings and are normally replaced whenever a banjo fitting is disconnected.
- Inspect the piston and bore for scoring before reassembly
- Replace banjo crush washers each time a fitting is loosened
- Use fresh brake fluid when bleeding the system
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6801278 |
| UPC | 90127959466 |
| Caliper type | T4 |
| Coverage | 1 caliper |
| Seal type | O-ring |
| O-ring material | EPDM rubber |
| O-ring rim shape | Square |
| Pressure seals included | Yes |
| Weather seals included | Yes |
| Pad abutment clips | Stainless steel, included |
| Bleeder screw dust cap included | Yes |
| Bleeder screw included | No |
| Country of origin | USA |
Vehicle fitment
It is matched to the Baer T4 caliper rather than to a vehicle model, so the caliper type is the deciding factor.
Confirm your caliper is a T4 before ordering, since no vehicle years, models or trims are given for this kit.
Installation notes
The bleeder screw is not included, so keep the existing bleeder screw or plan for a replacement. Fit the new seals and abutment clips with the caliper fully disassembled and cleaned, and bleed the brake line after reassembly. Brake caliper work affects stopping power, so test the pedal before driving.
What’s included
Pressure and weather seals, stainless steel pad abutment clips, banjo crush washers and a bleeder dust cap, for one T4 caliper.
Not included: bleeder screw and the caliper itself.











