Overview
The Baer Brakes 6920102 is a one-piece, full cast short hat replacement rotor for the right side of select Baer Brake systems. It measures 12.000 inch across and .810 inch thick, with a slotted, drilled and zinc-plated surface.
The hat has a 2.783 inch register and an overall height of 1.988, with 5 studs on a 4.75 inch circle. The rotor is vented and directional, and it is sold one rotor at a time.
Key features
- Full cast, one-piece short hat construction
- Slotted, drilled and zinc-plated finish
- Curved vane design for optimum cooling
- Vented, directional braking surface
- Dynamic balanced for vibration-free performance
- Cast iron material
Hub fit and center bore
Short hat rotors bolt to the hub through a flange, and the center bore locates the rotor so the studs carry the load. A proper fit depends on the stud pattern, the center bore and a clean, flat hub face. Any mismatch can cause vibration, runout or loose studs, so check the fit before the first drive.
Because a one-piece hat is cast together, the whole assembly is replaced rather than the hat alone. Pads, caliper brackets and wheel bearings should be inspected at the same time, since uneven wear in those parts often shows up on the rotor first. If vibration appears after installation, have runout checked before continuing to drive.
- Clean rust and debris from the hub face
- Replace studs or nuts that are stretched or damaged
- Recheck lug nut torque after the first few drives
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6920102 |
| UPC | 844165036203 |
| Axle side | Right |
| Construction | Full cast, one piece |
| Material | Cast iron |
| Outside diameter | 12.000 inch |
| Nominal thickness | .810 inch |
| Stud/lug hole quantity | 5 |
| Stud/lug hole circle diameter | 4.75 inch |
| Center hole diameter | 2.783 inch |
| Overall height | 1.988 |
| Drum in hat | No |
| Rotor type | Vented |
| Brake surface | Directional |
| Surface finish | Slotted, drilled and zinc plated |
| ABS tone ring included | No |
| Emission code | 6 |
| Grade type | Performance |
| Country of origin | USA |
| Sold as | Each |
Vehicle fitment
Its 5 x 4.75 inch bolt pattern and 2.783 inch center hole are the measurements to match against your hub.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Install the right-side rotor on the right side only, since the surface is directional. The hat has no drum built in. Have a qualified technician check hub fit before the vehicle returns to service.
What’s included
One right-side one-piece short hat rotor, sold individually.
Not included: ABS tone ring.
