Overview
The Baer Brakes 6919116 is a 12.000 x 1.020 inch replacement brake rotor for the left side, a one-piece full cast rotor with a slotted, drilled and zinc-plated surface. It is made for select Baer Brake systems, which makes it a service part for owners replacing a worn left rotor in an existing Baer setup.
The rotor is directional and made for the left side only, so it cannot stand in for a right-side part. The castings are purpose built, with curved vanes for cooling and dynamic balancing for smooth running. It has a drum in hat, a 2.78 inch center hole and an overall height of 2.406 inch.
No vehicle, model year or chassis code is given for this part number. Use the bolt pattern, center hole and overall height to check fit against the Baer system you already own.
Key features
- Slotted, drilled and zinc-plated surface type
- One-piece full cast construction in cast iron
- Curved vane design intended to help cooling
- Dynamic balanced for smooth, vibration-free running
- Directional rotor made for the left side only
- Drum in hat
Slotted and drilled rotors
Slots and drilled holes cut into the friction surface to help clear pad material, gas and water from the contact area. They can help in wet or muddy conditions, where a clean surface matters more. They also expose more edges, so inspect them more often for cracks at the holes and slots, especially after hard use or off-road water crossings.
Pads for slotted rotors often wear a little faster and can be noisier when new, so choose a pad compound that suits your driving. Zinc plating protects the rotor between uses, but it does not replace the need to inspect the friction surface. Remove surface rust from the hub before fitting, and bed in new pads gradually to keep braking smooth.
- Inspect slots and holes for cracking
- Expect some pad noise when new
- Keep the zinc finish intact during handling
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6919116 |
| UPC | 844165054498 |
| Size (diameter x thickness) | 12.000 Inch X 1.020 Inch |
| Outside diameter | 12.000 Inch |
| Overall height | 2.406 Inch |
| Stud/lug hole quantity | 4 |
| Stud/lug hole circle diameter | 4.25 Inch |
| Center hole diameter | 2.78 Inch |
| Material | Cast iron |
| Construction | Full cast, one piece |
| Surface type | Slotted, drilled and zinc plated |
| Rotor type | Vented |
| Brake surface | Directional |
| Drum in hat | Yes |
| ABS tone ring included | No |
| Axle | Left |
| Grade type | Performance |
| Emission code | 6 |
| Sold as | Each |
| Country of origin | USA |
Vehicle fitment
It is made for select Baer Brake systems. Measure your hub against the 4 X 4.25 Inch bolt circle and the 2.78 Inch center hole before choosing it.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Mount only the left-side rotor on the left hub, since the directional design is made for one side. Compare the drum in hat and overall height with the rotor being replaced. A qualified technician should verify the brake installation before the vehicle is driven.
What’s included
One replacement rotor, sold as each. Rotors are sold individually, so the opposite side needs its own part.
Not included: Brake pads, calipers, hub hardware and fasteners are not included with this rotor.
