Overview
The Baer Brakes 6801233 is a 1.375 inch S4 caliper rebuild kit that services one caliper. It supplies the seals, pad abutment clips and bleeder caps used to rebuild an S4 caliper of that size.
The kit includes 4 weather seals and 4 pressure seals made of EPDM rubber, 4 stainless steel pad abutment clips, and 2 bleeder caps. The O-rings have a 1.375 inside diameter and a square rim shape. The bleeder screw is not included.
If you are not certain of your piston size, Baer’s technical department can help before you order.
Key features
- Rebuilds one Baer S4 caliper in the 1.375 inch size
- 4 weather seals and 4 pressure seals
- 4 stainless steel pad abutment clips
- 2 bleeder caps
- EPDM rubber O-ring seals with a square rim shape
Before rebuilding a caliper
Rebuilding a brake caliper restores its ability to hold pressure and apply the pads evenly. Seals harden and swell with age and heat, and dirt or moisture that enters around a piston can cause sticking, fluid leaks or a soft pedal. Replacing the seals as a set during a rebuild addresses those wear points before they become a problem on the road.
Before disassembly, check the piston bore and piston face for scoring, pitting or rust. A damaged bore usually needs machining or a new caliper body, and a new seal will not seal over it. Clean all passages with fresh brake fluid and avoid petroleum-based solvents, which can swell rubber seals.
Abutment clips, pads and the bleeder screw are often replaced at the same time. Worn clips can let pads rattle or wear unevenly. Check the bleeder threads before reusing the old screw, since a stripped thread can cause leaks at the bleed point.
- Inspect the piston bore for scoring or corrosion
- Replace pad abutment clips when they show wear
- Use fresh brake fluid for the bleed
- Tighten fittings to the vehicle’s service specification
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 6801233 |
| UPC | 90127960202 |
| Caliper type | S4 |
| Size | 1.375 inch |
| O-ring inside diameter | 1.375 |
| O-ring material | EPDM rubber |
| O-ring rim shape | Square |
| Seal type | O-ring |
| Weather seals | 4 |
| Pressure seals | 4 |
| Pad abutment clips | 4, stainless steel |
| Bleeder caps | 2 |
| Bleeder screw included | No |
| Coverage | 1 caliper |
| Sold as | Kit |
| Country of origin | USA |
Vehicle fitment
The kit is matched to the S4 caliper in the 1.375 inch size rather than to a vehicle model, so caliper type and piston size decide suitability. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm the caliper type and piston size before ordering, since no vehicle years, models or trims are given.
Installation notes
The kit is for rebuilding a caliper, so the caliper must be disassembled and cleaned before the new seals go in. Keep the existing bleeder screw, since one is not included. Bleed the brake line after reassembly and test the pedal before driving.
What’s included
4 weather seals, 4 pressure seals, 4 abutment clips and 2 bleeder caps, for one S4 caliper.
Not included: bleeder screw.












