Overview
The Baer Brakes 54121-020 is a front set of Claw performance rotors for the 2003–2005 Ford Excursion and the 2003–2004 Ford F-250 and F-350 Super Duty, all in 2WD form. Each one-piece, full-cast vented rotor is a direct replacement with a cross-drilled and slotted friction surface, and the set includes an ABS tone ring.
The friction surface is built to let gases and dust escape from between the pad and rotor, which Baer says gives a more consistent pedal feel and reduced brake fade. The rotors carry a zinc-plated finish for a bright look behind open-center wheels and an enhanced vane structure for cooling. The mounting pattern is 8 studs, so check the stud count against your truck before fitting.
Key features
- Slotted and cross-drilled friction surface for gas and dust escape
- Enhanced vane structure for cooling and durability
- Chamfered cross-drilled holes to help reduce stress cracking
- ABS tone ring included with the set
- Zinc-plated finish visible in open-center wheels
- Premium, mill-balanced direct replacement rotor
Towing and heavy loads
Heavy-duty trucks put much more heat into the front brakes when towing or descending grades, so the friction surface and vent passages are working near their limit. Pad compound and brake fluid condition matter as much as the rotor. Fluid that has absorbed moisture can boil under sustained braking and reduce pedal firmness even with new rotors fitted.
Because the rotors are large and heavy, use lifting help during mounting and support the caliper so the brake hose is not strained. Check the hub and wheel bearing while the rotors are off, and bed in new pads gradually before towing.
- Use pads rated for towing or heavy loads when the truck pulls a trailer
- Flush old brake fluid if the fluid has not been changed recently
- Check the ABS ring and sensor when the hub is open
- Re-torque wheel nuts after the first few trips
Specifications
| Brand | Baer Brakes |
|---|---|
| Part number | 54121-020 |
| UPC | 844165045779 |
| Axle position | Front |
| Drive | 2WD |
| Rotor type | Vented, one-piece, full cast |
| Surface type | Slotted and cross-drilled |
| Brake surface | Directional |
| Material | Cast iron |
| Disc finish | Zinc plated |
| Grade | Premium |
| Stud/lug hole quantity | 8 |
| Mounting bolt hole circle diameter | 170 |
| Outside diameter | 330.96 |
| Overall height | 143.5 |
| Discard thickness | 36.1 |
| ABS tone ring included | Yes |
| Emission code | 6 |
| Country of origin | CN |
| Sold as | Set |
Vehicle fitment
Fits the front position of these vehicles:
- 2003–2005 Ford Excursion, 2WD
- 2003–2004 Ford F-250 Super Duty, 2WD
- 2003–2004 Ford F-350 Super Duty, 2WD, single rear wheel (SRW) trucks only
The F-350 entry does not cover dual rear wheel trucks. Model years outside the listed ranges are not included. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This set includes the ABS tone ring, so no separate ring is needed for these trucks. Rotors of this size are heavy, so use appropriate lifting help during mounting.
What’s included
A pair of direct replacement front rotors with ABS tone ring, sold as a set.
Not included: Pads are not part of this kit.














