Overview
The ARB RD163 is a Dana 60 air locking differential with 30 splines and 4.10 down gearing. It works as a selectable locker: air engages the lock so both axle shafts turn together, giving full spool traction when one wheel loses grip. No specific vehicles are named for this part, so the fitment section below explains how to confirm compatibility.
The RD163 is made for rough terrain driving, where an open differential sends power mostly to the wheel with the least traction. Engagement requires an onboard air compressor, which is not supplied with the locker.
Key features
- Pneumatic selectable locker that converts an open differential to full spool
- Supplies full power to both wheels in low traction
- Built for 30 spline axles
- Listed with 4.10 down gearing
- Fits rear or front axle locations
- Requires an ARB onboard air compressor to activate
Setting up the air system
An air locker is only as reliable as the air system behind it. The compressor, its wiring, the air lines and the switch form one circuit, and a leak anywhere in that circuit can stop the lock from engaging. Mount the compressor where it stays dry and away from heat, use fittings rated for the pressure it produces, and route lines clear of the driveshaft, springs and exhaust.
Test the system before a trip. Run the compressor, engage the locker on level ground and listen for the change in how the axle sounds. If the lock does not hold, look for a leak at a fitting or a weak fuse before assuming the differential has failed. Keep a spare fuse and a short length of line in the recovery kit.
- Drain moisture from the air tank regularly
- Route lines through grommets where they pass metal
- Test the switch and indicator before each trip
- Carry a spare fuse for the compressor circuit
Specifications
| Brand | ARB 4×4 Accessories |
|---|---|
| Part number | RD163 |
| UPC | 7000028981 |
| Differential type | Selectable air locker |
| Axle manufacturer | Dana |
| Axle type | Dana 60 |
| Axle spline count | 30 splines |
| Gear ratio | 4.10 down |
| Axle location | Rear|Front |
Vehicle fitment
Fit is set by the axle, so match the Dana 60 housing, 30 spline shafts and 4.10 down gearing to your axle before choosing this locker.
Axles with a different spline count or gear ratio need a different locker. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The locker will not engage without an air supply, so plan the compressor and its air lines before axle work starts. Replacing a differential also involves carrier and gear setup, which a qualified axle shop should handle. Support the vehicle on jack stands before working underneath it.
What’s included
Included: the RD163 air locking differential itself.
Not included: ARB onboard air compressor, which is required to activate the locker.







