Overview
The Fab Fours FF17-D4371-1 is an Aero Series front bumper without a guard for 2017 to 2018 Ford F-150 trucks, including the Raptor. It is built from tube and plate steel in black powder coat.
The Aero Series is an ultra light hybrid bumper. It fits high and tight to the contours of the vehicle and weighs 45 lb with no guard. It retains the factory skid plate and has a center mount for a Rigid Industries 20-inch LED light bar.
Fab Fours adds that the Aero Series is engineered to retain new technology features such as Adaptive Cruise Control and Park Assist with the optional M3850-1 bracket. The bumper is available in a no guard or pre-runner guard option and is made in the USA.
Key features
- Fits the 2017 to 2018 Ford Raptor
- Lightweight: 45 lb with no guard, 55 lb with the pre-runner guard
- Retains the factory skid plate
- Greater tire clearance
- Center mount for a Rigid Industries 20-inch LED light bar (not included)
- 11 ga. U.S. steel with 1.75-inch diameter, .120 wall tubing
- Optional M3850-1 relocation bracket for factory technology features
- Two-stage black powder coat
Ultra light bumper trade-offs
Hybrid bumpers that combine tube and plate steel try to keep weight low while keeping strength where it matters. A lighter front end can ease lifting during installation and reduce load on the front suspension, but the bumper still has to carry mounting loads and recovery forces. Frame brackets and their bolts remain the key part of the structure, so check them whenever the truck is serviced.
Choosing between a no guard and a pre-runner guard version comes down to how much front coverage is wanted and how much weight is acceptable. A no guard bumper keeps the front face open, which suits street use and simple light bar mounting. A guard adds protection to the nose of the truck, so consider how much brush and rock contact the truck sees.
Driver assist sensors sit behind or near the front fascia, so any change to bumper position may affect them. Before fitting, confirm what features the truck has and whether a relocation bracket is needed. After installation, check that the sensors are clear and aligned, and keep the bumper face clean so the sensors can read properly.
- Check frame bracket bolts at each service
- Keep sensor faces clear of mud
- Touch up powder coat chips early
Specifications
| Brand | Fab Fours |
|---|---|
| Part number | FF17-D4371-1 |
| UPC | 5810114763 |
| Type | Aero Series front bumper, no guard |
| Position | Front |
| Width | Full |
| Material | 11 ga. U.S. steel and tubing, 1.75-inch diameter, .120 wall |
| Finish | Two-stage black powder coat |
| Weight | 45 lb with no guard |
| Dimensions | Length 84 in, height 30 in, width 26 in |
| Fit type | Direct fit |
| Light mounts | Included |
| Winch mount | Not included |
Vehicle fitment
Fab Fours lists FF17-D4371-1 for the 2017 to 2018 Ford F-150 (Raptor).
The 2015 to 2017 and the 2009 to 2014 F-150 trucks are outside this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The bumper bolts on through brackets tied directly into the frame. The M3850-1 relocation bracket is optional and is the way Fab Fours retains factory technology features.
What’s included
- Aero Series front bumper without guard in black powder coat
- Frame brackets
Not included: The LED light bar and the optional M3850-1 relocation bracket.














