Overview
The Addictive Desert Designs Stealth “R” Rear Bumper, part number R013401280103, is a black powder coated rear bumper for the 2009–2014 Ford F-150.
Addictive Desert Designs says its welders handcraft each bumper from .120 wall steel tube with fully boxed frame horns and laser cut skid plates. The Stealth R bolts on with stainless steel hardware, with no cutting or welding, and it adds two dually light mounting locations and holes for backup sensors.
Key features
- Fully boxed frame horns
- Steel tube construction, .120 wall
- Laser cut skid plates, tabs and plates for a precise fit
- Hammer black powder coat with satin black panels
- Two dually light mounting locations, lights not included
- Backup sensor holes
- Direct fit with stainless steel hardware
Dually lights and backup sensors
A rear bumper sees more dirt, rock contact and recovery load than most people expect. After rough trail use, check the frame bolts and the bumper’s mounting points, and look for cracks in the welds around the tube joints. Tighten anything that has backed off before the next outing.
If you add dually lights, plan the wiring before you mount them. Run the harness along the frame where it will not rub, and fuse it close to the power source. Sensors and lights both need clear sight lines, so test the setup on level ground before a long drive.
- Use grommets where wires pass through metal
- Keep sensor wiring clear of the tow area
- Clean mounting surfaces before reinstalling hardware
Specifications
| Brand | Addictive Desert Designs |
|---|---|
| Part number | R013401280103 |
| UPC | 70000666672 |
| Product type | Rear bumper |
| Model line | Stealth R |
| Position | Rear |
| Construction | Steel tube, .120 wall |
| Finish | Hammer black powder coat |
| Panel finish | Satin black |
| Hardware | Stainless steel |
| Fitment type | Direct fit, no cutting or welding |
| Light mounts | 2 dually light mounts |
| Backup sensors | Holes included |
| Receiver hitch | No |
| Tire carrier | No |
| D-ring mounts | Not included |
Vehicle fitment
It fits the 2009–2014 Ford F-150, including the SVT Raptor.
Model years outside 2009–2014 and other Ford models are not covered by this part number. Confirm your vehicle’s year, model and trim before ordering.
What’s included
- Stealth R rear bumper with stainless steel mounting hardware
Not included: dually lights and D-ring mounts.














