Overview
The Addictive Desert Designs Venom Rear Bumper, part number R012231280103, is a black powder coated rear bumper for the 2009–2014 Ford F-150.
Addictive Desert Designs builds the bumper with a fully boxed frame, .120 wall steel tube construction and laser cut skid plates, and says its welders handcraft each unit. It bolts on with stainless steel hardware and needs no cutting or welding. The bumper has two mounting locations for dually lights and holes for backup sensors.
Key features
- Fully boxed frame horns
- Tube construction in .120 wall steel
- Laser cut skid plates, tabs and plates for a precise fit
- Hammer black powder coat with satin black panels
- Two mounting locations for dually lights, with the lights not included
- Holes for backup sensors
- Direct fit with stainless steel hardware, no cutting or welding
Protecting a steel rear bumper
Steel rear bumpers spend their lives close to the road and in mud, so the finish is the first line of defense against rust. Inspect the powder coat after hard trail use and touch up chips with matching paint before corrosion starts. Pay attention to the welds and mounting tabs, where moisture collects.
Rear bumpers also carry the weight of the tailgate and any rear-facing equipment. Check that the tailgate still clears the bumper after installation, and make sure the lights, sensors and any wiring are secured so they do not snag on brush or rub through insulation.
- Tighten stainless hardware after the first few trips
- Rinse mud from the skid plate and frame horns
- Replace cracked wiring loom before it fails
Specifications
| Brand | Addictive Desert Designs |
|---|---|
| Part number | R012231280103 |
| UPC | 70000666666 |
| Product type | Rear bumper |
| Position | Rear |
| Construction | Steel tube, .120 wall, fully boxed frame horns |
| Finish | Hammer black powder coat |
| Panel finish | Satin black |
| Hardware | Stainless steel |
| Fitment type | Direct fit, no cutting or welding |
| Light mounts | 2 dually light mounts |
| Backup sensors | Holes included |
| Receiver hitch | No |
| Tire carrier | No |
| D-ring mounts | Not included |
Vehicle fitment
The Venom rear bumper R012231280103 fits the 2009–2014 Ford F-150, including the SVT Raptor.
This part number does not cover F-150 model years outside 2009–2014, or other Ford trucks. Confirm your vehicle’s year, model and trim before ordering.
What’s included
- Venom rear bumper with stainless steel mounting hardware
Not included: dually lights and D-ring mounts.
















