Overview
The Addictive Desert Designs Stealth Fighter front bumper, part number F011052520103, is a full-width steel front bumper with a winch mount for the 2010-2014 Ford F-150 SVT Raptor. The bumper combines traditional pre-runner tubing with an encapsulating panel design and carries a Hammer black powder coat with Satin black panels.
The bumper has fully boxed frame horns, .120 wall steel tube construction, laser cut skid plates, tabs and plates, and stainless steel hardware. It has a 1/4-inch steel winch mount plate with a 10,500 lbs winch plate limit, so keep winch pull at or under that limit. It is made in the U.S.A.
The top mount takes a 20-inch light bar and dual 6-inch light bars, and the side mounts take 6-inch SR Rigid bars. The bumper has an ADD logo cutout, and photographed options may vary.
Key features
- Pre-runner tubing combined with an encapsulating panel design
- Fully boxed frame horns
- 1/4-inch steel winch mount plate
- Winch plate limit of 10,500 lbs
- Top mount for a 20-inch light bar and dual 6-inch light bars
- Side mounts for 6-inch SR Rigid bars
- Laser cut skid plates, tabs and plates for a precise fit
- Direct fit, no cutting or welding, with stainless steel hardware
- Made in the U.S.A.
Light and winch setup tips
Light bars change the load on a bumper and the wiring that runs to it. A 20-inch bar on the top mount and smaller lights at the sides add weight and wind resistance, so aim them to avoid blinding oncoming traffic and mount them snug so they do not vibrate loose. Clamping points should be checked before the lights are powered.
Wire lights through a relay with a fuse close to the battery, and route harnesses away from the winch and the frame edges. Check the light brackets and bolts after rough trails, since vibration works loose fasteners faster than normal road driving. A tidy wiring loom also makes future repairs easier.
- Use rubber grommets where wires pass through metal
- Aim light bars low enough to avoid glare
- Confirm the lighting setup is legal where you drive
Specifications
| Brand | Addictive Desert Designs |
|---|---|
| Part number | F011052520103 |
| UPC | 70000711055 |
| Product | Stealth Fighter front bumper |
| Material | Steel, .120 wall tube; 1/4 in winch plate |
| Bumper color | Hammer black |
| Panel color | Satin black |
| Finish | Powder coat |
| Width | Full |
| Position | Front |
| Winch plate limit | 10,500 lbs |
| Top mount | 20 in light bar and dual 6 in light bars |
| Side mount | 6 in SR Rigid bars |
| Hardware | Stainless steel |
| Winch mount | Included |
| Light mounts | Included |
| D-ring mount | Not included |
| Origin | Made in the U.S.A. |
Vehicle fitment
The bumper fits the 2010-2014 Ford F-150 SVT Raptor.
Other F-150 model years and the later Raptor generation are not in the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The bumper is a direct fit that needs no cutting or welding. Keep winch pull within the 10,500 lbs plate limit, and wire any lights through a fused relay.
What’s included
- Front bumper with winch mount plate
- Light mounts
- Stainless steel hardware
Not included: the winch, lights and D-rings.









