Overview
The kit is required for installing Westin’s Diamond step rear bumpers, and it mounts the 63000 and 73000 bumpers to the truck. It has a diamond tread step design and is a rear position part.
The kit has a diamond tread step design, and it is a rear position part.
Key features
- Diamond tread step design
- Mounts Westin 63000 and 73000 rear bumpers
- Required for installing Diamond step rear bumpers
- Rear location and position
Installation order
Diamond step rear bumpers depend on the mount being in place first, so the order of work matters. Start by clearing the rear frame area of rust and debris, then fit the mount loosely, set the bumper, and tighten everything once alignment is right. Keep the hardware sorted so the bolts go back to the matching holes.
Because the bumper is mounted through this kit, any stress from a rear collision or trail strike reaches the mount first. Look at the mount and its frame connections after a hard impact, and re-check torque after the first trips on rough roads. Rubber isolators or spacers, if your bumper uses them, should be checked for wear at the same time.
- Clear rust and debris from the frame area
- Fit the mount loosely before final tightening
- Check fasteners after the first rough drives
Specifications
| Brand | Westin |
|---|---|
| Part number | WES97900 |
| UPC | 26149979007 |
| Location | Rear |
| Position | Rear |
| Compatible bumpers | Westin 63000 and 73000 |
| Fitment type | Direct fit |
Vehicle fitment
The fitment data covers the 1987–1992 Jeep Comanche in its Base, Chief, Eliminator, Laredo, and Pioneer versions.
The fitment data does not include other Jeep models or Comanche model years outside 1987 to 1992. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the kit is required for installing the Diamond step rear bumpers, it has to be fitted before those bumpers are mounted to the truck.
What’s included
Not included: the Westin 63000 or 73000 rear bumper, which this kit mounts to the truck.









