Overview
The Warn VR12 GEN II 96820 is a 12000 lb electric winch with a 12V motor, a 216:1 gear ratio and 94 ft of 3/8 wire rope. It is a newer model with updated styling and performance, and it is intended for three-quarter ton and one-ton pickups and larger, heavier rigs.
No vehicle is named for the VR12 GEN II, so fitment depends on your mounting setup. The main features are the convertible control pack, the Albright contactor, the one-piece tie plate and the cone brake, covered below.
Key features
- Convertible control pack that supports upright or low-profile mounting
- Waterproof Albright contactor for reliable winch control
- One-piece tie plate in place of several tie bars
- Cone brake that holds the full-rated load
- Hawse fairlead
- Remote switch with a 12 ft lead
Mounting the control pack
The control pack can be set up upright or low-profile, and the two layouts place it differently relative to the winch. Choose the configuration before the winch goes on the mount, because changing it later means reworking the cable routing. Plan the position so the pack is reachable and protected from mud and flying debris.
Once the layout is set, check that the contactor and cable runs clear the frame and any moving parts. Use fused battery cable for the motor and keep the remote lead away from the rope. A clean, well-supported install makes the winch easier to service when a connection or seal needs attention.
- Decide upright or low-profile before mounting
- Keep cable runs clear of moving parts
- Support the control pack to limit vibration
Specifications
| Brand | Warn |
|---|---|
| Part number | 96820 |
| UPC | 12748968207 |
| Rated line pull | 12000 lbs |
| Motor | 12V |
| Gear ratio | 216:1 |
| Type of winch | Electric |
| Remote control | Remote switch, 12 ft lead |
| Wire rope | 94 ft of 3/8 rope |
| Line type | Cable |
| Fairlead | Hawse |
| Contactor | Waterproof Albright |
Vehicle fitment
No make, model or year is named for this winch. It is intended for three-quarter ton and one-ton pickups by capacity, so check your bumper and mount before choosing a mount.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Choose upright or low-profile mounting for the control pack before you install the winch, because the two configurations place the control pack differently. Use fused battery cable for the motor as the manufacturer directs.
What’s included
The winch includes 94 ft of 3/8 rope, a hawse fairlead and a remote switch with a 12 ft lead. Plan for mounting hardware separately before installing.









