Overview
The Warn ProVantage 3500 is a 3500 lb electric winch for larger ATVs and Side x Sides, model 90350 with UPC 12748903505. It suits heavier jobs on smaller utility vehicles and pairs steady operation with substantial pulling power.
The winch pairs a 1.4 HP permanent magnet motor on 12V power with a 3-stage planetary gear train at 154:1. Warn highlights the all-metal gear housing and the fully sealed motor and drive train, which it says keep the elements out. The hook, tie rods and body have a corrosion-resistant black finish. Control is through a handlebar mini-rocker with a socket, and the specifications list a 4-way roller fairlead. No year, make or model is named for this winch.
Key features
- 3500 lb rated line pull for larger ATVs and Side x Sides
- 1.4 HP permanent magnet motor on 12V
- 3-stage planetary gear train at 154:1 with roller disk brake
- All-metal gear housing and fully sealed motor and drive train
- Handlebar mini-rocker control with socket
- 4-way roller fairlead
- Black powder coat finish
Choosing a winch for ATV use
A winch on an ATV or Side x Side earns its keep at low speed, when the machine is stuck in mud, sand or a ditch and the line has to do steady work. Electric winches like this one draw a lot of current under load, so the battery, charging system and wiring matter as much as the winch itself. A well-maintained battery at full charge keeps the motor from slowing down halfway through a pull.
Synthetic and steel lines behave differently. Synthetic line is lighter to handle but can be cut by sharp edges, so use a tree strap or snatch block where the line rubs. Wear gloves when handling the line and keep your body out of the bight during every pull, since a snapping line can travel further than expected.
- Check the cable before each use for fraying or flat spots
- Keep the handlebar control wiring clear of steering and throttle
- Replace a fairlead roller that has grooves worn into it
Specifications
| Brand | Warn |
|---|---|
| Part number | 90350 |
| UPC | 12748903505 |
| Rated line pull | 3500 lbs |
| Winch motor | 1.4 HP permanent magnet |
| Voltage | 12V |
| Control | Handlebar mini-rocker with socket |
| Gear train | 3-stage planetary |
| Gear reduction ratio | 154:1 |
| Braking action | Roller disk |
| Drum size | 2.0 in diameter x 2.9 in length |
| Wire cable | 3/16 in x 50 ft |
| Fairlead | 4-way roller |
| Overall dimensions | 13.1 in L x 4.53 in W x 4.69 in H |
| Finish | Black powder coat |
| Warranty | Limited Lifetime Warranty |
Vehicle fitment
It is designed for larger ATVs and Side x Sides. Check the mounting position and overall dimensions of 13.1 in L x 4.53 in W x 4.69 in H against your vehicle before fitting it.
It is not tied to a particular year, make or model. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The specifications list no mounting bolt pattern, so measure the winch against your mounting bracket before drilling. Run the power leads with fuse protection and keep the handlebar mini-rocker wiring away from the steering and throttle controls.
What’s included
The specifications list the winch with a 3/16 in x 50 ft cable, a 4-way roller fairlead and a handlebar mini-rocker control with socket.
Not included: a mounting bracket.












