Overview
The Tuff Country 22810K is a 2.5 inch front and 2 inch rear lift kit for the 1981–1996 Ford Bronco, the 1984–1990 Ford Bronco II and the 1981–1996 Ford F-150. It uses front coil springs and a radius arm bracket, with a rear axle pivot bracket and rear blocks to set the back of the truck.
The kit includes a 4 inch block and U-bolts for the rear axle, plus a hardware bag for installation. Shocks are not included, so the existing shocks are used or new shocks are fitted separately.
The brand has produced suspension lift kits since 1988 and backs its lift kits with a limited lifetime warranty. Several Bronco and F-150 trims are covered.
Key features
- 2.5 inch front lift
- 2 inch rear lift
- Front coil springs
- Radius arm bracket
- Rear axle pivot bracket
- 4 inch block and U-bolts
- Hardware bag included
Front end care and checks
Coil spring suspensions on these Broncos and F-150s carry the weight through the spring seat and the radius arm bracket, so the mounting hardware sees more load after a front lift. Look over the spring seats, bushings and radius arm joints at regular intervals for cracking, oil or looseness. Worn bushings can allow the axle to shift under braking, which makes steering feel vague.
The front and rear heights on a split lift should be compared once the truck is level and loaded the way it normally runs. Shocks and steering components often need attention after a height change, and a track bar or drag link that was adequate before may need replacing if it is worn. Re-check torque on all brackets after the first few drives.
- Spring seats and coil isolators for cracks
- Radius arm bushings for wear
- Front and rear level once loaded
- Hardware torque after the first drives
Specifications
| Brand | Tuff Country |
|---|---|
| Part number | 22810K |
| UPC | 698815009921 |
| Front lift | 2.5 inch |
| Rear lift | 2 inch |
| Suspension type | Coil spring kit |
| Rear lift method | Block |
| Rear block | 4 inch |
| Shocks | Not included |
Vehicle fitment
It fits the 1981–1996 Ford Bronco (Custom, Eddie Bauer, Ranger XLT, XL, XLS, XLT, XLT Lariat, XLT Nite and XLT Sport), the 1984–1990 Ford Bronco II, and the 1981–1996 Ford F-150 (Base, Custom, Eddie Bauer, Ranger, Ranger Lariat, Ranger XLT, Special, XL, XLS, XLT and XLT Lariat).
Ford models and years outside those listed, including the F-250 and the 1997 and later trucks, are not covered. Verify your year, model and trim match before you order.
Installation notes
The front coil springs and the radius arm bracket change the front suspension geometry, so check the alignment after installation. The rear uses a pivot bracket and blocks, so check the rear axle position as well.
What’s included
The kit includes front coil springs, a radius arm bracket, a rear axle pivot bracket, rear blocks, a 4 inch block, U-bolts and a hardware bag.
Not included: Shocks.









