Overview
The Trail Gear Hi-Lift Jack Mount, part number 180078-KIT, is a laser-cut steel bracket that holds a Hi-Lift jack on 1-3/4-inch tubing. It is a weld-on mount, so it is meant to be welded in place rather than bolted to the vehicle. The mount comes unpainted, and no specific vehicles are named for it.
Trail Gear designed the mount so the jack stays put on the trail. The ends are coped so they fit the tubing for welding, and a precision-drilled bolt with a cotter-style pin keeps the nut from rattling loose.
Key features
- Laser cut from 3/16-inch steel, then CNC formed
- Coped ends for welding to 1-3/4-inch tubing
- 1/2-inch thick bolt with a precision hole for a hair-pin or cotter-style pin
- Rubber pads between the jack and the mounts to limit vibration noise
- Velcro strap holds the jack handle in place
- Second hole accepts a padlock to secure the jack
Preparing for a weld-on install
A weld-on jack mount is a permanent change to the frame or bumper area, so plan the work before cutting or welding. Clean the mounting surface to bare metal, confirm the tubing fits the coped ends, and mark the jack’s position so the handle can be reached from the outside. Test-fit the bracket with the jack in place before any weld is made.
Welding near fuel lines, brake lines and wiring needs protection and careful heat control. Remove or shield nearby parts where possible, and let the weld cool before loading the jack. After installation, check the welds for cracks at each service, since repeated trail impacts can fatigue a joint over time.
- Clean the mount area to bare metal
- Test-fit with the jack before welding
- Shield fuel, brake and wiring lines
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 180078-KIT |
| UPC | 70000621474 |
| Jack mounting type | Tube jack mount |
| Steel thickness | 3/16-inch |
| Tubing size | 1-3/4-inch |
| Bolt thickness | 1/2-inch |
| Finish | Unpainted |
| Attachment | Welded |
Vehicle fitment
It is universal fit, but because it welds to tubing, fit depends on the mounting location and the 1-3/4-inch tubing. Check both against your vehicle’s build before welding.
Installation notes
The mount must be welded on, and it comes unpainted, so finishing is up to the installer. Welding steel near fuel lines, brake lines and wiring calls for care and an experienced welder.
What’s included
The mount with its rubber pads, Velcro handle strap, and a precision-drilled bolt for a cotter-style pin.
Not included: the Hi-Lift jack and the welding work.









