Overview
The Trail Gear 144039-1-KIT is a rear disc brake kit that adds GM-style loaded calipers and vented rotors and connects to OEM Toyota brake lines on the 1995–2004 Toyota Tacoma.
The caliper bracket is 3/8in. thick and laser cut, and it attaches with grade 10.9 mounting bolts. The larger GM-style calipers ship fully loaded, and the vented rotors are made for this application. Full color install instructions are included with the kit.
Key features
- Two GM-style loaded calipers and two vented rotors
- 3/8in. thick laser cut caliper brackets
- Grade 10.9 mounting bolts
- DOT approved stainless steel braided brake lines
- Brake lines fit the GM calipers on one end and OEM Toyota brake lines on the other, so no new fittings are required
- Full color install instructions included
Preparing the brake system
Before installing a rear disc conversion, check the brake fluid, the master cylinder and the proportioning setup. Disc brakes on the rear typically change the balance of braking force, so the valve that controls rear pressure matters as much as the calipers. Look over the existing drum hardware, parking brake cable and hydraulic lines so that nothing is left out of the job. A clean, well-bled system makes the new components easier to set up and test.
After installation, bleed the brakes fully and test pedal feel at low speed before driving on trails or highways. Recheck the caliper bolts and bracket fasteners after the first short drive, because new hardware settles. Inspect the rotors for scoring and the pads for uneven wear at regular service intervals, and replace the brake fluid on a set schedule. Stainless braided lines resist swelling, but they still need periodic visual checks for chafing.
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 144039-1-KIT |
| UPC | 70000621367 |
| Product type | Rear disc brake kit |
| Caliper type | OEM-style (GM-style loaded calipers) |
| Rotor type | Standard, GM-style vented |
| Brake position | Rear |
| Caliper bracket | 3/8in. thick, laser cut |
| Mounting bolts | Grade 10.9 |
| Brake lines | DOT approved, stainless steel braided |
| Color | Natural |
| Fitment type | Direct fit |
| Master cylinder requirement | 2 lb. residual valve, or a 1in. bore master cylinder |
Vehicle fitment
The manufacturer fitment list for the Trail Gear 144039-1-KIT includes the following vehicles and trims:
- 1995–2004 Toyota Tacoma (Base, Limited, Pre Runner, S-Runner, SR5)
The list covers the Tacoma from 1995 to 2004 only; it does not include later Tacoma generations or other Toyota trucks. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit requires either a 2 lb. residual valve or a 1in. bore master cylinder, which many pickups and 4Runners already have after an upgrade. The brake lines attach to the OEM Toyota brake lines without new fittings, and full color installation instructions are included.
What’s included
Two brake rotors, two loaded brake calipers, two stainless steel braided brake lines, two brake caliper brackets, installation hardware and installation instructions.
Not included: The 2 lb. residual valve or 1in. bore master cylinder that the kit requires is not part of the kit.









