Overview
The Trail Gear 300481-KIT is a weld-on differential armor plate for the face of a factory 8 inch Toyota solid axle housing. It is curved to fit snugly over the housing and is made from 1/4 inch thick plate steel.
Fit is by axle housing: factory front or rear 79-95 8 inch Toyota solid axle housings, and the 91-97 front FJ 80 axle. Confirm your housing before welding.
Key features
- Weld-on mounting onto the housing face
- Curved plate designed to fit snugly over the housing
- 1/4 inch thick plate steel construction
- Raw finish
Welding the plate on
Welded armor depends on a clean, sound housing face. Grind off paint, rust and oil from the contact area before fitting, and check the curve of the plate against the housing so it sits flat. Tack the plate in a few spots first, check alignment, then complete the welds. Heat can warp thin housing metal, so work in short passes and let the area cool between them.
A plate of this thickness protects the front of the housing from rocks and stumps, but it adds weight and changes the ground clearance slightly. Consider the skid plates on the same vehicle, since they share the same stress path. Inspect the welds after trail use for cracks, especially at the corners where stress builds.
- Clean the contact area to bare metal
- Tack and check alignment before full welds
- Inspect weld corners after hard trail use
Specifications
| Brand | Trail Gear |
|---|---|
| Part number | 300481-KIT |
| UPC | 70000659338 |
| Material | Plate steel, 1/4 in thick |
| Finish | Raw |
| Mounting | Weld-on |
| Housing fit | Factory front or rear 79-95 8 in. Toyota solid axle housings |
| Also fits | 91-97 front FJ 80 axle |
Vehicle fitment
Fitment is by axle housing, not by vehicle model or year. The plate fits factory front or rear 79-95 8 inch Toyota solid axle housings and the 91-97 front FJ 80 axle.
Other axle housings, including Dana axles, are not covered by these stated fits. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because this is a weld-on plate, it is welded to the housing rather than bolted. Have a qualified welder fit and weld it, and check the fit against the housing before the weld is made.
What’s included
Welding is the only mounting method, so plan the job around that.
Not included: welding labor and consumables.









