Overview
The Tekonsha 3050-P is a trailer brake control wiring harness for wiring a brake controller unit through a plug and play connection. Part number 3050-P identifies it in Tekonsha’s range.
This harness is universal fit, so it is not built around a particular tow vehicle. The controller and trailer wiring decide whether it suits your setup.
Key features
- Plug and play harness for brake controller units
- Wires meant to be matched to their functions without guessing
- Universal fit, so it is not built around a particular tow vehicle.
- Tekonsha part number 3050-P
Matching the harness to your controller
Trailer brake controllers send a proportional signal to the trailer’s electric brakes, and the harness carries that signal along with the power and ground circuits. Before connecting, confirm the controller’s connector style and wire functions match the harness. A mismatched plug can leave the trailer brakes inactive or send power down the wrong circuit.
Trailer wiring is exposed to road salt, water and vibration, so it deserves regular attention. Look for green corrosion, cracked insulation and loose pins at the connectors. Recheck the ground connection too, since a weak ground is a common cause of poor brake response. Wiring that has been spliced or modified is a good candidate for replacement at the next service.
- Test the trailer brake and running light functions after hookup
- Keep the harness clear of the hitch ball and safety chains
- Apply dielectric grease to connector terminals to slow corrosion
Specifications
| Brand | Tekonsha |
|---|---|
| Part number | 3050-P |
| UPC | 783192005359 |
| Fitment | Universal Fit |
Vehicle fitment
The 3050-P carries universal fit, so it is not vehicle-specific. Year, make and model do not limit it; compatibility is set by the connectors on your controller and trailer.
The 3050-P is not limited to particular tow vehicles. Confirm your vehicle’s year, make and model against the controller connectors before ordering.
Installation notes
Keep the trailer unplugged from the tow vehicle while the harness is routed and connected, since a live circuit can short during routing.
What’s included
The 3050-P is a wiring harness only. Not included: a brake controller unit.









