Overview
The Supersprings SuperCoils SSC-51 is a heavy duty replacement coil spring with 2480 lbs. of coil capacity, built to replace overworked and sagging coil springs and level sag. Its position is rear, and it can be used front or rear depending on the application. It fits 2009–2010 and 2011–2018 Ram 1500 trucks.
The spring is made in the U.S.A. and needs no maintenance. It increases load support, and typical installation takes about one to two hours. Keep loads within the GVWR rating at all times.
Key features
- Replaces overworked and sagging coil springs
- Levels sag and increases load support
- 2480 lbs. coil capacity
- Requires no maintenance
- Made in the U.S.A.
Load ratings and rear springs
A replacement coil spring restores height and load support when the original spring has taken a set over time. Sagging springs often show a low rear corner, uneven tire wear and a bottomed-out feel over bumps. Replacing the spring is a practical fix, but it does not change the vehicle’s rated payload.
Before buying, consider the typical load. A spring with more capacity supports heavier loads, but the truck still has to stay within its rated gross weight. Bump stops, shock condition and the rear axle position also affect how a spring sits, so inspect them while the springs are out.
Springs are usually replaced in pairs so both sides sit at the same height and rate. Check the shocks for leaks and mounts for wear at the same time, since a new spring can load them differently. Re-check the rear height after a few weeks of normal use.
- Weigh the typical load before choosing a spring
- Check bump stops and shock condition
- Replace rear springs in pairs
- Re-check rear height after a few weeks
Specifications
| Brand | Supersprings |
|---|---|
| Part number | SSC-51 |
| UPC | 700008420321 |
| Coil capacity | 2480 lbs. |
| Position | Rear (copy also says front or rear) |
| Typical installation | About one to two hours |
| Maintenance | None required |
| Fitment type | Direct fit |
Vehicle fitment
Fits 2009–2010 Dodge Ram 1500 in Laramie, SLT, ST, Sport, TRX and TRX4 trims, and 2011–2018 Ram 1500 in Big Horn, Express, HFE, Laramie, Laramie Limited, Laramie Longhorn, Limited, Lone Star, Outdoorsman, R/T, Rebel, SLT, ST, Special Service, Sport, Tradesman and Tradesman HD trims.
Ram 2500 and Ram 3500 models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Typical installation takes about one to two hours. Never load the truck beyond its GVWR rating.
What’s included
The package is a heavy duty replacement coil spring. Check the contents against your installation before starting.









