Overview
The Smittybilt 17191-01 is a driver-side front 6 inch fender flare for the Jeep Wrangler YJ. It is molded in textured UV-stable ABS, can be painted, and is sold individually. It is a direct-fit part.
Smittybilt describes these as extended fender flares that are easy to install and require only minimal drilling. The flare is 6 inches of extra width, and it can be painted to match the vehicle. The texture is a molded finish, and the material is UV stable.
Check local regulations on tire coverage before installing.
Key features
- Driver side front fender flare
- 6 inch extra width
- Textured UV-stable ABS
- Paintable, can be painted to match
- Requires minimal drilling for installation
- Sold individually
Driver-side front flare care
A single front flare sits near the steering and the front tire, so it sees more spray, grit and contact than the rear flares. Check the flare edge for scuffs or cracks every few months, and clean it with mild soap rather than harsh solvents that can dull paint and textured finishes. Clearance matters most at full steering lock, so turn the wheel both ways after installation and look for rubbing against the tire or fender liner.
When a flare is replaced, the mounting points and fasteners should be checked, since loose hardware can let the flare shift on rough roads. Plan a second look after the first week of driving, and keep a record of how the flare was fitted in case you need to adjust it later.
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | 17191-01 |
| UPC | 631410090468 |
| Product type | Front fender flare |
| Location | Front, driver side |
| Width / coverage | 6 inches |
| Material | Textured UV-stable ABS |
| Finish | Paintable |
| Quantity | Sold individually |
| Fitment type | Direct fit |
Vehicle fitment
Based on the product title, the Smittybilt 17191-01 is for the Jeep Wrangler YJ, which is the 1987-1995 Wrangler (YJ).
This flare is for the YJ Wrangler. Other Wrangler generations such as the TJ and the JK are not covered. It is the driver-side front flare only. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Test fit the flare before final installation, and follow the instructions for drilling, painting and mounting.
- Clean and dry the mounting surfaces, and check clearance to tires through full steering and suspension travel.
- Tighten fasteners to the specified values, and use thread locker or sealant only where the steps call for it.
- Check local regulations on tire coverage and exterior equipment.
- Re-check the hardware after the first miles of driving and at regular service intervals.
What’s included
One driver-side front fender flare.
Not included: The passenger-side flare and the rear flares are separate. Paint is not included.









