Overview
The Smittybilt 76614 SRC Gen2 is a rear bumper with a built-in Class III 2-inch receiver, for 2007–2018 Jeep Wrangler (JK) two-door and four-door models.
It is made from 3/16-inch steel, and its solid plate center sections wrap around the frame horns and lower crossmembers. The receiver is built into the bumper and bolts directly to the factory mounting points. The design gives fender-to-fender protection with raised corners for better entry and exit angles.
The bumper is built to protect the truck without limiting off-road travel. The corners are raised for better entry and exit angles, and the bumper gives fender-to-fender protection.
Key features
- Built-in Class III 2-inch receiver
- Anti-rattle provision for the receiver hitch
- Solid plate center sections that wrap the frame horns and lower crossmembers
- Two D-ring mounts, towable and welded inside and out
- New solid D-ring and jack point mount
- Backup light cut-out, with lights included
- Raised corners for entry and exit angles
- Modular design; tire carrier can be added later (part S/B76857)
Towing and recovery setup
A receiver built into the bumper keeps the hitch close to the frame, which helps the load sit where the structure is strongest. Before towing, check the vehicle’s own hitch and load ratings, because the receiver can only be as strong as the vehicle it is mounted to. Use a pin and clip rated for the load, and keep the receiver free of mud so it seats fully each time.
Recovery is the other main job for this rear end. The D-ring mounts take shackles for winching or pulling, and the solid plate sections help spread the load across the frame. Inspect the mounts after heavy pulls, since shock loads concentrate at the welds and fasteners.
- Check the vehicle’s hitch and load ratings before towing
- Use a rated pin and clip in the receiver
- Inspect D-ring welds after heavy recovery pulls
Specifications
| Brand | Smittybilt |
|---|---|
| Part number | 76614 |
| UPC | 631410125665 |
| Product line | SRC Gen2 |
| Position | Rear |
| Fitment type | Direct fit |
| Material | 3/16-inch steel |
| Finish | Two-stage textured matte black powder coat |
| Receiver hitch | Built-in Class III, 2-inch |
| D-ring mount | Included, two |
| Backup lights | Cut-out provided; lights included |
| Recommended shackle | Smittybilt 3/4-inch D-ring shackle, part 13047B |
| Tire carrier | Not included; can be added later (S/B76857) |
Vehicle fitment
It fits the 2007–2018 Jeep Wrangler (JK) in two-door and four-door models. Trims covered are Rubicon, Sahara, Sport, Sport S and X, plus the Unlimited version of each.
It fits the JK only, not the JL or the 1997–2006 TJ. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The bumper bolts directly to the factory mounting points. Smittybilt recommends its 3/4-inch D-ring shackle, part 13047B, for the D-ring mounts.
What’s included
The bumper, with its built-in receiver, two D-ring mounts and backup lights.
Not included: A tire carrier. The design is modular, and a tire carrier can be added later as part S/B76857.


































