Overview
The Smittybilt JH44 is a black 2 inch receiver hitch that bolts onto a Smittybilt tube bumper. It is designed specifically for Smittybilt tube bumpers, so it gives a tube bumper a receiver hitch where it would not otherwise have one.
The hitch is a rear receiver with a 2 inch by 2 inch receiver size and a Class II weight rating. It does not fit with a roll pan, so it should only be considered on a tube bumper setup without a roll pan.
Key features
- Bolt-on installation
- Designed for Smittybilt tube bumpers
- 2 inch by 2 inch receiver
- Class II weight class
- Black finish
Planning a tube bumper hitch
A receiver on a tube bumper gives you a towing point where the bumper otherwise has none, but the bumper is then carrying the load. Before adding a hitch, confirm that the bumper is mounted solidly to the frame and that its bolts are tight. Think about how often you will tow, since frequent use adds wear to the mounting points and the bolts that hold the hitch.
Plan your setup around the load you intend to tow. A Class II rating suits lighter trailers, so keep trailer weight and tongue weight within the rating and avoid overloading the receiver. Inspect the bolts and welds after the first few trips and periodically after that. Tighten any loose fasteners and replace parts that show cracks or distortion.
Specifications
| Brand | Smittybilt |
|---|---|
| UPC | 631410001075 |
| Product type | Receiver hitch for tube bumpers |
| Color | Black |
| Mounting | Bolt-on, rear |
| Receiver size | 2 inches x 2 inches |
| Weight class | Class II |
| Roll pan compatibility | Does not fit with roll pan |
Vehicle fitment
No vehicle model years are listed. The hitch is designed for Smittybilt tube bumpers, so check that your bumper is a Smittybilt tube bumper before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The hitch is a bolt-on design, so it attaches to the tube bumper with bolts. Check the hitch against your bumper’s mounting points before you start.
What’s included
The package is the 2 inch receiver hitch itself. Check the package contents against your installation before starting.












