Overview
The Skyjacker C125S is a 2.5 inch Softride front leaf spring for 1973–1991 Chevrolet and GMC full-size 4×4 trucks and SUVs, including the K10, K20, K30, K5 Blazer, Blazer, Jimmy and Suburban models. It is sold as a single spring, so a pair requires two.
The spring is built as a progressive multileaf pack with a load capacity equal to or greater than OE. It is made with American steel and carries a limited lifetime warranty. Bushings are not included, and bushing part number SKYSE11C is recommended.
Key features
- 2.5 inch Softride leaf spring for the front position
- Progressive multileaf pack construction
- Load capacity equal to or greater than OE
- Made with American steel
- Single spring; two are needed for a pair
- Limited lifetime warranty
- Direct fit for the listed vehicles
Leaf spring replacement basics
Leaf springs carry the weight of the front axle and control how the truck rides and how it responds to load. A progressive multileaf pack softens the ride when the truck is unloaded and stiffens as weight increases, which suits trucks that carry gear as well as drive on pavement.
Replacing one spring changes the ride height on that side, so match springs as a set per axle when possible. Check the shackles, hangers and spring eyes for wear, since a new spring on worn hardware will not sit correctly. Bushings take the most movement, so replacing them with the spring keeps the axle working as designed.
Signs a leaf spring is worn include sagging at one corner, a broken or shifted leaf, squeaks at the eye, and uneven tire wear. Check for these when the truck is raised and supported on stands before any new part goes in.
- Check spring eyes and shackles for wear
- Inspect U-bolts and tighten them fully
- Replace bushings with the spring when practical
Specifications
| Brand | Skyjacker |
|---|---|
| Part number | C125S |
| UPC | 803696117782 |
| Product type | Softride leaf spring |
| Nominal lift | 2.5 inch |
| Position | Front |
| Spring quantity | Single spring (two needed for a pair) |
| Lift height range | 0 to 4.99 inches |
| Construction | Progressive multileaf pack |
| Material | American steel |
| Bushings included | No |
| Recommended bushing | SKYSE11C |
| Warranty | Limited lifetime |
| Fitment type | Direct fit |
Vehicle fitment
It fits Chevrolet Blazer (1973–1974 and 1987–1991), K10 and K10 Suburban (1973–1986), K20 and K20 Suburban (1973–1986), K30 (1977–1986), K5 Blazer (1975–1986), V10 and V20 (1987), V10 Suburban and V20 Suburban (1987–1988), V1500 and V2500 Suburban (1989–1991) and V30 (1987). It also fits the GMC Jimmy (1973–1991), K15 and K1500, K25 and K2500, K35 and K3500, and the 1987 V1500, V2500 and V3500, in the trims shown.
Model years and models outside the stored list are not covered. Rear springs are not covered by this front spring. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Follow the installation steps carefully and tighten all fasteners to the torque values for your vehicle. Support the vehicle on jack stands or a lift on level ground, never on a jack alone, and re-check fastener tightness after the first miles of driving.
Suspension work changes ride height, steering geometry and brake line and driveline clearances, so professional installation is recommended, and a wheel alignment is advised afterward. Check your local regulations on vehicle lift height and equipment.
Replace springs and bushings as a set per axle where recommended, so plan to use two springs for a pair, and install the recommended bushings or an equivalent.
What’s included
One front Softride leaf spring.
Not included: bushings (Skyjacker recommends SKYSE11C), and a second spring for the other side.


