Overview
The Rock Krawler RK04909 is a bare steel rear coil over bracket for 2007–2017 Jeep Wrangler JK vehicles, covering 2-door and 4-door models. It provides a rear coil over mounting point for lift heights from 1.5 to 5.5 inches.
Rock Krawler builds this bracket from plate steel, laser cut and precision welded, and describes its construction as heavy. The RK04909 is made in the U.S.A. and is intended for the rear axle position only.
Key features
- Rear mounting position
- Plate steel construction
- Laser cut and precision welded
- Bare steel finish
- 2-door and 4-door models
- Lift range of 1.5 to 5.5 inches
Rear axle geometry
Rear coil over brackets change how the axle sits under the frame, which affects pinion angle, driveshaft length and brake line routing. A rear lift that moves the axle too far can shift these angles and cause vibration. Set the rear shock mount height with the axle position in mind, rather than focusing on the bracket alone.
Rear suspension parts take steady loads and sudden hits from trail obstacles. Check the driveshaft U-joints and slip yoke for full engagement, and inspect brake lines for stretch or rubbing. Rear springs and shocks are often replaced together with the brackets to keep ride height and damping matched.
- Measure pinion angle after installation
- Check the driveshaft slip yoke for engagement
- Inspect brake lines for stretch at full droop
Specifications
| Brand | Rock Krawler |
|---|---|
| Part number | RK04909 |
| UPC | 700007685711 |
| Position | Rear |
| Construction | Plate steel |
| Finish | Bare steel |
| Lift range | 1.5 to 5.5 in. |
| Body style | 2-door and 4-door |
| Origin | Made in the U.S.A. |
Vehicle fitment
It fits 2007–2017 Jeep Wrangler (JK) vehicles in 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X trims, plus the Unlimited trims of the same names.
Models outside the JK generation, including the TJ, LJ and JL Wranglers and all Cherokee and Grand Cherokee vehicles, are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Set the rear shock mount height to suit your lift, then check driveline angles and rear axle positioning. The listed lift range runs from 1.5 to 5.5 inches.
What’s included
The bracket is sold on its own, so plan for the rear shocks and springs as separate purchases.
Not included: coil over shocks and springs for the rear position.







