Overview
The Rigid Industries Center Bumper Mount Kit, part 46529, is a center mount for one 20-inch E-Series or one 20-inch SR-Series LED light. It is used to position a single light at the center of a bumper.
It is sold for either series, so choose an E-Series or SR-Series light before ordering. The light is not included.
Key features
- Center mounting position
- Fits one 20-inch E-Series LED light
- Fits one 20-inch SR-Series LED light
- Single light per kit
Choosing a bumper light setup
A center bumper light works best when it sits where it clears the grille and stays aligned with the vehicle’s centerline. Before mounting, look at the shape of the bumper surface, since a flat or gently curved area makes alignment easier to check and keeps the light square to the road. Test-fit the light with the bolts loose, then tighten once the angle is right.
Because the kit holds only one light, plan the wiring for the light and any switch in advance. Route cable away from moving parts and sharp edges, and secure it with clips so vibration does not loosen the connections. Recheck the mounting hardware after the first few trail runs, and look for cracked brackets or worn grommets during routine inspections.
- Check clearance to the grille and winch before tightening
- Keep the light centered on the vehicle’s front axle line
- Inspect the mount and wiring after rough trail use
Specifications
| Brand | Rigid Industries |
|---|---|
| Part number | 46529 |
| UPC | 849774013089 |
| Mount position | Center |
| Light size | 20 inch |
| Compatible lights | E-Series or SR-Series 20 in LED light |
| Lights included | No |
Vehicle fitment
Confirm fit for your vehicle’s year, model and trim before ordering. Measure the bumper’s center area and compare it with the kit before installing.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Use a fused relay for the wiring, and look up local rules before running the light on public roads.
What’s included
- Center Bumper Mount Kit
Not included: One 20-inch E-Series or SR-Series LED light.









