Overview
The Rhino-Rack 2500 Fitting Kit, part number DK377, is a full set of pads and clamps for a two bar Rhino-Rack 2500 roof rack. The kit has four santoprene pads and four black metal clamps, and it fits the 2014–2018 Chevrolet Silverado 1500 in the Custom, High Country, LS, LT, LTZ, SSV and WT versions, and the 2014–2018 GMC Sierra 1500 in the Base, Denali, SLE and SLT versions.
The clamps are strong and resist corrosion. The DK377 is the two bar version of this fitting, and the one bar fitting for the same trucks is the DK377H.
Key features
- Four santoprene pads
- Four black metal clamps
- Anti-corrosive clamp finish
- Full kit for a two bar rack
Checking clamps on pickup racks
Pickup racks take a steady load from wind and cargo, and the clamps are what keep the rack bars locked to the pads. Over time, the clamp arms can flex, and the threads can loosen if the fasteners were not fully seated. A quick check of each clamp by hand, looking for movement against the roof, catches most of these changes before they become a problem on the road.
Corrosion is the other common issue. Black metal clamps resist rust, but a scratch that reaches bare metal can start a spot of corrosion that spreads under the coating. Clean any grit off the clamps, touch up small scratches, and replace any clamp that is cracked or badly rusted rather than trying to repair it.
- Check each clamp for movement by hand
- Touch up small scratches before rust spreads
- Replace cracked or badly rusted clamps
Specifications
| Brand | Rhino-Rack USA |
|---|---|
| Part number | DK377 |
| Part type | Full fitting kit, two bar 2500 system |
| Pads | 4 santoprene |
| Clamps | 4 black metal |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2014–2018 Chevrolet Silverado 1500 in the Custom, High Country, LS, LT, LTZ, SSV and WT versions, and the 2014–2018 GMC Sierra 1500 in the Base, Denali, SLE and SLT versions. Confirm fit for your vehicle’s year, model and trim before ordering.
The Silverado and Sierra HD trucks and the 2019 and later 1500 models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
All four pads and clamps are needed for a two bar rack, so set them all before tightening. Tighten them in an even pattern, then recheck the fit once the rack has been loaded.
What’s included
A four-pad, four-clamp set for two bar Silverado and Sierra racks.









